Zanussi ZCG 7900X manual Parts Required, Levelling the Appliance, Fitting the Stability Bracket

Page 45

INSTALLATION

1. PARTS REQUIRED

The loose hotplate parts are packed in the polystyrene fitment on top of the hotplate.

2. LEVELLING THE APPLIANCE

If the appliance requires levelling or its height adjusting (from the hotplate to any working surface), the procedure below must be followed:

1.Adjustment to suit floor conditions or height is obtained by rotating clockwise or anticlockwise the feet, at the front and rear of the appliance.

2.A spirit level should be placed on one of the oven shelves to confirm the appliance is correctly levelled.

3.FITTING THE STABILITY BRACKET

It is recommended that if the appliance is to be installed with a flexible supply pipe a stability bracket (SK.4729.A) is fitted and is available from your supplier (see Important Safety Requirements, Page 43). These instructions should be read in conjunction with the leaflet packed with the stability bracket.

1.Place the appliance in its intended position and level appliance.

2.Mark off 300mm from the left hand side of the appliance as shown in dimension 'A', Fig 2a. This is the centre line of the fixing bracket.

3.Draw a line 100mm from the front edge of the levelling feet (see Fig.2a) and remove appliance from its position. Mark off dimension 'B' (see Fig.2a) back from this line on the centre line of the bracket to locate the front edge of the lower bracket. Fix lower bracket (with two fixing holes) to the floor then measure the height from floor level to engagement edge on back of appliance, dimension 'C' of Fig.2b.

4.Assemble upper bracket to lower bracket so that underside of bracket is dimension 'C' +3mm above floor level.

Reposition appliance and check that top bracket engages into appliance back as shown in Fig. 2b.

487mm (B)

100mm

(A)

300mm

(C)

Fig.2a

Fig.2b

45

Image 45
Contents ZCG Introduction For your safetyContents Hotplate Lighting the cookerGrill/second oven GrillSecond oven To turn off any burner Main ovenOven light Oven will lightHeat control GrillCooking positions PreheatingPositioning food on the grid Grill pan and handleGrill pan should be fitted with the handle for grilling Burner sizes HotplateAre reaching across the hotplate Take care to avoid burns and scalds when youUse pans with flat bases. They are more stable Than pans which are warpedHelpful hints Ovens Heat zonesOven shelves Baking trays and dishes Condensation RoastingOven cooking chart Main oven Mins. per ½kg 1lb and 25 mins 30 40 mins Base Medium Oven cooking chart Second ovenLamb Shelf on Medium Base Well DoneFruit pie shortcrust 25 35 mins Baked custard 50 60 mins 45 60 minsTurn the selector knob to Manual then turn to Time Setting Electronic timerTo set the time of day To use the countdownSetting the controls for automatic use Setting knob Either directionAutomatic control To cook? G 7 9 0 0 How long will Turn the selector knob to Food takeDisplay What time do Turn the selector knob to You want Food to beHints and tips for automatic cooking Slow cooking Food preparation slow cookingPlease note There is no slow cook on the second oven Do not cook casseroles over 3kg 6lb Thaw thoroughly before cookingLeft over food should be cooled quickly and refrigerated Care and cleaning For your safety Crown to body Do not try to force the crown on to the body Clean the grill frequently using hot soapy waterOvens Main oven cleaning cycle To carry out a cleaning cycle Remove the oven shelvesGeneral Top oven cleaning cycle Remove the oven shelfSet the oven to mark 5 for at least 30 minutes To remove the outer glass Cleaning between the outer and inner door glassInstalling the cooker Cleaning The Door GlassLocation Make sure that a stability bracket is fittedPositioning Cooker dimensionsHeight to hotplate 900mm 920mm Width 594mm DepthGeneral information For your safety Connecting to the electricity supplyMoving your cooker Replacing the oven light bulb Check What is wrong and why?Probably a fault 7 0 5 9 2 9 9 2 Service and spare partsCustomer Care Department Installation Instructions Connections DimensionsIgnition GrillMain Oven Important Safety RequirementsSecond Oven GeneralLocation of Appliance Parts Required Levelling the ApplianceFitting the Stability Bracket Connection to the Electricity Supply Connecting to GASChecking the Grill Pressure TestingChecking the Hotplate Checking LID SHUT-OFF DeviceChecking the Main Oven Controls Checking the Main OvenAutomatic Operation Checking the Second Oven Checking the Main Oven LightGeneral Note ZCG7900X Guarantee ConditionsPage From the Electrolux Group. The worlds No choice Electrolux Household Appliances Limited