Zanussi ZDI 112 manual Fault code and malfunction

Page 19

Fault code and malfunction

continuous flashing of the start/cancel indicator light

3 flashes of the end of programme indicator light

The programme does not start

Possible cause and solution

Anti-flood device is activated

Close the water tap and contact your local Service Force Center.

• The dishwasher’s door has not been properly closed

Close the door

The main plug is not plugged in Insert the main plug

The fuse has blown out in the household fuse box Replace the fuse

Delay start has been set

If dishes are to be washed immediately, cancel the delay start

Once these checks have been carried out; close the dishwasher’s door and switch on the appliance. Press the button of the programme that was running before the intervention of the alarm. The programme will continue from the point at which it was interrupted.

If the malfunction or fault code reappears con- tact the Service Force Centre.

For other fault codes not described in the above chart, please contact your Service Force Cen- tre.

Contact your local Service Force Centre, quot- ing the model (Mod.), product number (PNC) and serial number (S.N.).

This information can be found on the rating plate located on the side of the dishwasher door.

So that you always have these numbers at hand, we recommend you to make a note of them here:

Mod. : . . . . . . . . . . . . . . . . . . . . . . .

PNC :. . . . . . . . . . . . . . . . . . . . . . . .

S.N. : . . . . . . . . . . . . . . . . . . . . . . . .

19

Image 19
Contents Dishwasher ZDI Contents Correct use Safety informationGeneral safety Child safetyControl panel InstallationStarting the washing programme Washing programmes First use When using tablets that integrate rinse aid and detergentWater hardness Mmol/l Set the water softenerUse of salt Setting the water softener electronically see table Setting the water softener manually see tableFilling with dishwasher salt Only before filling with Filling with rinse aid Adjusting the dosage of rinse aidLoading cutlery and dishes Are of limited suitability Lower basket Adjusting the height of the upper basketMaximum height of the dishes Upper basketUnloading the dishwasher Use of detergentDetergent tablets Cleaning the filters Care and cleaningEnvironmental concerns Possible cause and solution Fault code and malfunctionSomething not working Fault code and malfunction Wash results are not satisfactory Technical dataConsumption values Full load 12 standard place settingsHints for test institutes Water inlet hose with safety valve InstallationWater connection Must be removed . Fail Drain hoseFitting under a counter Electrical connectionLevelling Page Page Page 156991060-00-19102007 Subject to change without notice