Zanussi ZDI 112 Something not working, Fault code and malfunction, Possible cause and solution

Page 18

CAUTION!

When a unit is no longer being used:

Pull the plug out of the socket.

Cut off the cable and plug and dispose of them.

Dispose of the door catch. This prevents children from trapping themselves inside and endangering their lives.

The symbol on the product or on its pack- aging indicates that this product may not be treated as household waste. Instead it should

be taken to the appropriate collection point for the recycling of electrical and electronic equip- ment. By ensuring this product is disposed of correctly, you will help prevent potential nega- tive consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product.

Something not working

The dishwasher will not start or stops during operation.

Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described in the chart, without calling out an engineer.

Switch off the dishwasher, open the door and carry out the following suggested corrective ac- tions.

Fault code and malfunction

continuous flashing of the start/cancel indicator light

1 flash of the end of programme indicator light The dishwasher does not fill with water

continuous flashing of the start/cancel indicator light

2 flashes of the end of programme indicator light The dishwasher will not drain

Possible cause and solution

The water tap is blocked or furred with limescale Clean the water tap

The water tap is turned off

Turn the water tap on

The filter (where present) in the threaded hose fitting at the water inlet valve is blocked

Clean the filter in the threaded hose

The water inlet hose has not been correctly laid or it is bent or squashed

Check the water drain hose connection

The sink spigot is blocked Clean out the sink spigot

The water drain hose has not been correctly laid or it is bent or squashed

Check the water drain hose connection

18

Image 18
Contents Dishwasher ZDI Contents Child safety Safety informationGeneral safety Correct useInstallation Control panelStarting the washing programme Washing programmes When using tablets that integrate rinse aid and detergent First useSet the water softener Water hardness Mmol/lUse of salt Setting the water softener manually see table Setting the water softener electronically see tableFilling with dishwasher salt Only before filling with Adjusting the dosage of rinse aid Filling with rinse aidLoading cutlery and dishes Are of limited suitability Upper basket Adjusting the height of the upper basketMaximum height of the dishes Lower basket Use of detergent Unloading the dishwasher Detergent tablets Care and cleaning Cleaning the filtersEnvironmental concerns Fault code and malfunction Possible cause and solutionSomething not working Fault code and malfunction Technical data Wash results are not satisfactoryFull load 12 standard place settings Consumption valuesHints for test institutes Installation Water inlet hose with safety valveWater connection Drain hose Must be removed . FailElectrical connection Fitting under a counterLevelling Page Page Page 156991060-00-19102007 Subject to change without notice