Zanussi ZDTS 101 user manual Load cutlery and dishes, Adjusting the dosage of rinse aid

Page 12

CAUTION!

Never fill the rinse aid dispenser with any other substances (e.g. dishwasher cleaning agent, liquid detergent). This would damage the appliance.

Top up the rinse aid indica- tor (B) becomes clear

Adjusting the dosage of rinse aid

Increase the dose if there are drops of water or lime spots on the dishes after washing.

Reduce the dose if there are whitish streaks on the dishes or a bluish film on glassware or knife blades.

Open the lid.

Set the dosage level. (The

 

dose is factory set in po-

 

sition 4).

Close the lid and press un- til it locks.

Load cutlery and dishes

Sponges, household cloths and any object that can absorb water may not be washed in the dishwasher.

Before loading the dishes, you should:

Remove all left over food and debris.

Soften remnants of burnt food in pans

When loading the dishes and cutlery, please note:

Dishes and cutlery must not impede the rotation of the spray arms.

Load hollow items such as cups, glasses, pans, etc. with the opening downwards so that water cannot collect in the container or a deep base.

Dishes and items of cutlery must not lie inside one another, or cover each other.

12

Image 12
Contents Dishwasher Zdts Contents Safety information General safetyChild safety Correct useInstallation Control panelSetting mode Release the Programme selection/Can- cel buttonAudible signals Indicator lightsWashing programmes Degree of soilType of load Programme descriptionFirst use Set the water softenerSetting the water softener manually see table Setting the water softener electronically see tableWater hardness Clarke Mmol/l Use of saltUse of dishwasher salt Use only special salt suitable for dishwashersUse of rinse aid Adjusting the dosage of rinse aid Load cutlery and dishesAre of limited suitability Adjusting the height of the upper basket Maximum height of the dishesUpper basket Lower basketUse of detergent Unloading the dishwasherDetergent tablets Care and cleaning Cleaning the filtersCleaning the spray arms Environment concerns Fault code and malfunction Possible cause and solutionWhat to do if… Wash results are not satisfactory Technical data Consumption valuesFull load 9 standard place settings Hints for test institutesInstallation Water inlet hose with safety valveWater connection Drain hose Must be removed . FailElectrical connection Fitting under a counterLevelling Page Page Page 117972110-012008