Zanussi ZDTS 101 Use of dishwasher salt, Use only special salt suitable for dishwashers

Page 10

1.Press the On/Off button. The appliance must be in setting mode.

2.Press and hold Programme selection/ Cancel button until programme light A flashes and programme light B illuminates with fixed light.

3.After a few seconds:

programme light B turns off

programme light A goes on flashing

End of programme light starts flashing: the number of flashes corresponds to

current level set. The flashing is repea- ted with a pause of a few seconds. Examples: 5 flashes, pause, 5 flashes, pause, etc... = level 5.

4.To change the level, press the Programme selection/Cancel button. Each time the button is pressed the level increases (level 1 follows level 10). The End of pro- gramme light indicates the new setting.

5.To memorise the operation, switch off the dishwasher.

Use of dishwasher salt

CAUTION!

Use only special salt suitable for dishwashers.

Unscrew the cap.

Only before filling with

 

salt for the first time, fill

 

the salt container with wa-

 

ter.

Using the funnel provided, pour in the salt until the container is filled with salt.

10

Image 10
Contents Dishwasher Zdts Contents Child safety Safety informationGeneral safety Correct useInstallation Control panelSetting mode Release the Programme selection/Can- cel buttonAudible signals Indicator lightsType of load Washing programmesDegree of soil Programme descriptionFirst use Set the water softenerWater hardness Clarke Mmol/l Setting the water softener manually see tableSetting the water softener electronically see table Use of saltUse of dishwasher salt Use only special salt suitable for dishwashersUse of rinse aid Adjusting the dosage of rinse aid Load cutlery and dishesAre of limited suitability Upper basket Adjusting the height of the upper basketMaximum height of the dishes Lower basketUnloading the dishwasher Use of detergentDetergent tablets Cleaning the filters Care and cleaningCleaning the spray arms Environment concerns Possible cause and solution Fault code and malfunctionWhat to do if… Wash results are not satisfactory Technical data Consumption valuesFull load 9 standard place settings Hints for test institutesWater inlet hose with safety valve InstallationWater connection Drain hose Must be removed . FailFitting under a counter Electrical connectionLevelling Page Page Page 117972110-012008