Zanussi ZDTS 101 user manual Installation, Water connection, Water inlet hose with safety valve

Page 22

cup racks: position A

Lower basket

Installation

WARNING!

Any electrical and/or plumbing work required to install this appliance should be carried out by a qualified electrician and/or plumber or compe- tent person.

Water connection

WARNING!

The dishwasher must not be connected to open water appliances or instantaneous water heat- ers. This dishwasher may be fed with either hot (max. 60°) or cold water. Nevertheless we ad- vise you a cold water supply.

WARNING!

Only use, for connection to the water mains, new hose-set; old hose-set must not be reused.

CAUTION!

If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes be- fore connecting the inlet hose.

Water inlet hose with safety valve

Connect the inlet hose to a water tap with an external thread of 3/4”.

After connecting the double-walled water inlet hose, the safety valve is next to the tap.

If the water inlet hose leaks, the safety valve cuts off the water supply.

22

Image 22
Contents Dishwasher Zdts Contents Child safety Safety informationGeneral safety Correct useInstallation Control panelSetting mode Release the Programme selection/Can- cel buttonAudible signals Indicator lightsType of load Washing programmesDegree of soil Programme descriptionFirst use Set the water softenerWater hardness Clarke Mmol/l Setting the water softener manually see tableSetting the water softener electronically see table Use of saltUse of dishwasher salt Use only special salt suitable for dishwashersUse of rinse aid Adjusting the dosage of rinse aid Load cutlery and dishesAre of limited suitability Upper basket Adjusting the height of the upper basketMaximum height of the dishes Lower basketUnloading the dishwasher Use of detergentDetergent tablets Cleaning the filters Care and cleaningCleaning the spray arms Environment concerns Possible cause and solution Fault code and malfunctionWhat to do if… Wash results are not satisfactory Technical data Consumption valuesFull load 9 standard place settings Hints for test institutesWater inlet hose with safety valve InstallationWater connection Drain hose Must be removed . FailFitting under a counter Electrical connectionLevelling Page Page Page 117972110-012008