Zanussi ZDTS 101 user manual Electrical connection, Fitting under a counter, Levelling

Page 24

Electrical connection

CAUTION!

Safety standards require the appliance to be earthed.

Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the supply where the appliance is to be installed.

The fuse rating is also to be found on the rating plate.

Always plug the mains plug into a correctly in- stalled shockproof socket. Multi-way plugs, connectors and extension cables must not be used.

This could constitute a fire hazard through over- heating.

If necessary, have the domestic wiring system socket replaced. In case that the electrical ca- ble has to be replaced, contact your local Serv- ice Force centre.

The plug must be accessible after the appliance has been installed.

Never unplug the appliance by pulling on the cable. Always pull the plug.

The manufacturer accepts no liability for failure to observe the above safety precautions.

Fitting under a counter

IMPORTANT!

Carefully follow the instructions on the enclosed template for building in the dishwasher and fit- ting the furniture panel.

24

WARNING!

The dishwasher must be secured against tilting. Therefore make sure that the counter it is fixed under, is suitably secured to a fixed structure (adjacent kitchen units cabinets, wall).

This dishwasher is designed to be fitted under a kitchen counter or work surface.

No further openings for the venting of the dishwasher are required, but only to let the wa- ter fill and drain hose and power supply cable pass through.

The dishwasher incorporates adjustable feet to allow the adjustment of the height.

During all operations that involve accessibility to internal components the dishwasher has to be unplugged.

Be sure that once the appliance has been in- stalled, it is easily accessible for the service engineer in the event that a repair is required.

Levelling

Good levelling is essential for correct closure and sealing of the door.

When the appliance is correctly levelled, the door will not catch on either side of the cabinet. If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level. (See enclosed template).

Image 24
Contents Dishwasher Zdts Contents Safety information General safetyChild safety Correct useInstallation Control panelSetting mode Release the Programme selection/Can- cel buttonAudible signals Indicator lightsWashing programmes Degree of soilType of load Programme descriptionFirst use Set the water softenerSetting the water softener manually see table Setting the water softener electronically see tableWater hardness Clarke Mmol/l Use of saltUse of dishwasher salt Use only special salt suitable for dishwashersUse of rinse aid Adjusting the dosage of rinse aid Load cutlery and dishesAre of limited suitability Adjusting the height of the upper basket Maximum height of the dishesUpper basket Lower basketUse of detergent Unloading the dishwasherDetergent tablets Care and cleaning Cleaning the filtersCleaning the spray arms Environment concerns Fault code and malfunction Possible cause and solutionWhat to do if… Wash results are not satisfactory Technical data Consumption valuesFull load 9 standard place settings Hints for test institutesInstallation Water inlet hose with safety valveWater connection Drain hose Must be removed . FailElectrical connection Fitting under a counterLevelling Page Page Page 117972110-012008