Zanussi ZDTS 101 user manual Setting mode, Release the Programme selection/Can- cel button

Page 5

Setting mode

The appliance is in setting mode when all programme lights are off and End of pro- gramme light flashes.

IMPORTANT!

Always remember that when performing opera- tions such as:

selecting a washing programme

setting the water softener

deactivation/activation of the audible signals

Programme selection/cancel button

the appliance MUST be in setting mode.

If a programme light is illuminated and End of programme light is illuminated with fixed light, the last performed programme is still set.

In this case the programme has to be cancelled:

1.Press and hold the Programme selection/ Cancel button until the light of the running programme turns off and the End of pro- gramme light is flashing.

2.Release the Programme selection/Can- cel button.

Starting the washing programme:

1.Press the On-Off button.

2.Press the Programme selection/cancel button once, the light of the last performed washing pro- gramme illuminates and the End of programme light flashes.

3.Press the Programme selection/cancel button as many times as necessary to illuminate the light corresponding to the desired programme.

4.Close the dishwasher’s door, the programme will start automatically.

IMPORTANT!

Once the programme has started, if you want to change the selection made you must cancel the wash- ing programme in progress.

Cancel the washing programme in progress:

1.Open the door.

2.Press and hold the Programme selection/cancel button until the light of the running programme turns off and the End of programme light is flash- ing.

3.Release the Programme selection/cancel but- ton.

4.Switch off the machine by pressing the On-Offbutton or select a new washing programme (check that there is detergent in the detergent dispenser.

5

Image 5
Contents Dishwasher Zdts Contents General safety Safety informationChild safety Correct useControl panel InstallationRelease the Programme selection/Can- cel button Setting modeIndicator lights Audible signalsDegree of soil Washing programmesType of load Programme descriptionSet the water softener First useSetting the water softener electronically see table Setting the water softener manually see tableWater hardness Clarke Mmol/l Use of saltUse only special salt suitable for dishwashers Use of dishwasher saltUse of rinse aid Load cutlery and dishes Adjusting the dosage of rinse aidAre of limited suitability Maximum height of the dishes Adjusting the height of the upper basketUpper basket Lower basketDetergent tablets Use of detergentUnloading the dishwasher Cleaning the spray arms Care and cleaningCleaning the filters Environment concerns What to do if… Fault code and malfunctionPossible cause and solution Wash results are not satisfactory Consumption values Technical dataHints for test institutes Full load 9 standard place settingsWater connection InstallationWater inlet hose with safety valve Must be removed . Fail Drain hoseLevelling Electrical connectionFitting under a counter Page Page Page 117972110-012008