Zanussi ZDTS 101 user manual Care and cleaning, Cleaning the filters, Cleaning the spray arms

Page 16

•Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes.

CAUTION!

When the washing programme has finished, it is recommended that the dishwasher is un- plugged and the water tap turned off.

Care and cleaning

Cleaning the filters

IMPORTANT!

NEVER use the dishwasher without filters. In- correct repositioning and fitting of the filters will produce poor washing results.

Clean filters A, B and C thoroughly under running water.

Turn the handle about 1/4	Remove filter A from the
turn anticlockwise and re-	base of the washing com-
move filters B and C.	partment.

Replace the filters and lock by turning the handle clockwise to the stop.

Cleaning the spray arms		If residues of soil have clogged the holes in the
NEVER try to remove the spray arms.		spray arms, remove them with a cocktail stick.
NEVER try to remove the spray arms.
16

Image 16

Contents Dishwasher Zdts Contents Safety information General safetyChild safety Correct useInstallation Control panelSetting mode Release the Programme selection/Can- cel buttonAudible signals Indicator lightsWashing programmes Degree of soilType of load Programme descriptionFirst use Set the water softenerSetting the water softener manually see table Setting the water softener electronically see tableWater hardness Clarke Mmol/l Use of saltUse of dishwasher salt Use only special salt suitable for dishwashersUse of rinse aid Adjusting the dosage of rinse aid Load cutlery and dishesAre of limited suitability Adjusting the height of the upper basket Maximum height of the dishesUpper basket Lower basketUnloading the dishwasher Use of detergentDetergent tablets Cleaning the filters Care and cleaningCleaning the spray arms Environment concerns Possible cause and solution Fault code and malfunctionWhat to do if… Wash results are not satisfactory Technical data Consumption valuesFull load 9 standard place settings Hints for test institutesWater inlet hose with safety valve InstallationWater connection Drain hose Must be removed . FailFitting under a counter Electrical connectionLevelling Page Page Page 117972110-012008