Operation
Hob burners control knobs
The symbols on the knobs mean that :
there is no gas supply
there is maximum gas supply
| there is minimum gas supply |
| |||||
Lighting | the | burners |
| ||||
| For easier | lighting, | proceed before putting |
| |||
)z | a pan on the pan support. |
| |||||
To light a burner: |
|
|
| ||||
turn the relevant knob |
| ||||||
| position ( | ), then push it down to ignite the |
| ||||
| burner. |
|
|
| Triple crown burner | ||
Only for model ZGS 682 ICT | |||||||
| |||||||
z | Upon ignition, keep the knob pushed down |
| |||||
| about | 5 seconds. | This will allow the | A | |||
| "thermocouple" (see diagram - letter D) to be | B | |||||
| heated and the safety device to be switched | ||||||
| off, otherwise | the | gas supply would be |
| |||
| interrupted. |
|
| D | |||
z | Then adjust the flame as required. | ||||||
C | |||||||
| If the burner does not ignite, turn the control knob | ||||||
|
| ||||||
| to zero, and try again. |
| A - Burner cap | ||||
| If you | cannot | light | the flame even after | B - Burner crown | ||
| C - Ignition electrode | ||||||
| severalattempts, check the "cap" (see diagram | ||||||
| D - Thermocouple (only in | ||||||
| - letter A) and the"crown" (see diagram - letter | ||||||
| model ZGS 682 ICT) | ||||||
| B) are in the correct position. | ||||||
|
|
8