Sherwood P-965 manual Entering a label, Correcting or clearing a label

ENGLISH

Entering a label			2	Press the LABEL button to enter the label
				input mode.
• This function can be operated on the input sources				Example ) When selecting VIDEO 1.
except TUNER, TAPE MONITOR and 8 CH
DIRECT.
Select the desired input source to enter its
1 label.
	STANDBY	POWER ON
	AUD1
	TUNER	VID1
	CD	VID2		Confirm your selection.
or	T.MON	VID3	4
	AUX	VID4
	PHONO	VID5
	PAGE1

•You can select “VID 6” on the page 2 of “AUD 1” on the remote control.

					• Then the next digit will flicker.
3	Select the character on the flickering digit.
					5	Repeat the above steps	and to enter
						the desired characters on the rest of the
						digits.
					• On up to 9 digits, the desired characters can be entered.
• Each time the MULTI CONTROL knob is rotated,					Note: If any of INPUT SELECTOR buttons is
the characters change as follows:						pressed while entering a label, the label input
						mode will be canceled.
Blank (		)
Alphabets: A~Z, a~z					6	Memorize the desired label.
Numerals: 0~9
Symbols:
Correcting or clearing a label					2	Repeat the steps ~	in “Entering a
						label” procedure.
1	Select the desired input source to be
	rectified or cleared.
		STANDBY		POWER ON	• To clear a label, make a blank on each digit and
			AUD1		memorize it, then the label is cleared and its factory
			TUNER	VID1	input source will be displayed.
			CD	VID2
		or	T.MON	VID3	• If the LABEL button is pressed for more than 3
			AUX	VID4
			PHONO	VID5	seconds, blanks will be made on all the digits at
			PAGE1
					once.

•You can select “VID 6” on the page 2 of “AUD 1” on the remote control.

40