Sherwood P-965 manual When selecting the Subwoofer

Press the CURSOR UP()/DOWN()

5 buttons to select the virtualization mode.

1 2 3

4 5 6

7 8 9

0

MI M2 M3

When selecting the SUBWOOFER

•When the subwoofer without built-in amplifier is connected to “SURROUND BACK RIGHT” terminals of the power amplifier, you should set “SUBWOOFER” to “PASSIVE”.

Press the CURSOR UP()/DOWN()

1 buttons to select the SUBWOOFER.

1 2 3

4 5 6

7 8 9

0

MI M2 M3

Note :

•When “S/B CH” is set to “2 CH” on the SPEAKER CONFIGURATION menu, the SUBWOOFER

cannot be selected.

1 2 3

4 5 6

7 8 9

0

MI M2 M3

•Each time these buttons are pressed, the virtualization mode changes as follows:

WIDE: This mode expands the front channel sound field.

REFERENCE: This is the standard mode.

Notes :

•When “WIDE” is selected as virtualization mode, you can select “2-SPEAKER”, “3-SPEAKER”, “4- SPEAKER” or “5-SPEAKER”.

•When “REFERENCE” is selected as virtualization mode, you can select “2-SPEAKER” or “3- SPEAKER” only.

Press the CURSOR LEFT()/RIGHT()

2 buttons to select the desired mode.

1 2 3

4 5 6

7 8 9

0

MI M2 M3

RNC-510

•Depending on your subwoofer type , you can select one of following types.

ACTIVE: Select this when connecting the powered subwoofer to “SW” of PREOUT jacks.

PASSIVE: Select this when connecting the subwoofer without built-in amplifier to “SURROUND BACK RIGHT” terminals of the power amplifier.

Note :

•If “SUBWOOFER” is set to “PASSIVE”, the SURROUND BACK RIGHT channel of the PREOUT jacks is automatically changed to SUBWOOFER

channel.

ENGLISH