Tricity Bendix TBG700 user manual Fitting the Hob into the Worktop

Page 20

Fitting the Hob into the Worktop

Carry out the building in of the hob as follows:

1.place the seals supplied with the hob on the front edge of the cut out. Then, place them at 50 mm from the side edges and at 10 mm from the rear edge, as shown in the diagram, taking

care that the seals meet without overlapping.

2. Place the hob in the cut out, taking care that it is centred.

3. Fix the hob with the relevant fixing clamps, supplied with the injectors kit (see diagram). When the screws have been tightened, the excess seal can be removed.

The edge of the hob forms a double seal which prevents the ingress of liquids.

Seal

20

Image 20
Contents TBG700 Welcome to the world of Electrolux Contents Important Safety Information InstallationChild Safety During UseService Environmental InformationDescription of the Hob Installation Using the hob correctly OperationHob burners control knobs Lighting the burnersBurner Minimum Maximum Diameter Pan Supports Maintenance and CleaningHob Top Burners Ignition electrodeSymptom Solution Something Not Working?Instructions for the Installer Engineer technical dataType of GAS Important safety requirements LocationInstallation Gas Connection Cut Out Size Building over a kitchen unit with door BuildingBuilding over a cupboard or drawer Fitting the Hob into the Worktop Electrical Connections This HOB Must be EarthedWiring Diagram Permanent ConnectionFault Finding Preliminary Electrical Systems CheckEarth Continuity Check Ignition System / Gas Ignition Pressure Testing CommissioningConversion from Natural Gas to LPG MethodStandard Guarantee Conditions Service and Spare Parts European Guarantee Page 35674-6903 02/07 R.0