Frigidaire 318205403 Checking Operation, Model and Serial Number Location

Page 7

ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS

3. Models: 32" Coil Elements Cooktops

1.Place cooktop into countertop opening and center unit in cutout.

2.Remove all surface units and drip bowls.

3.Unit clamp down information. Once unit is installed in counter opening, you must clamp unit down as shown in figure 12.

4.Put back all surface units and drip bowls.

5.Make electrical connections as outlined in "Electrical Connection" section.

Reach down through surface unit openings and install the four hold down retainers with screws as shown. Be certain cooking top is firmly retained to counter top.

Cooktop

Nylon spacer

 

 

 

 

 

 

4.Prior to tightening installation screws, exert downward pressure on burner box to assure flanges on burner box rest firmly on counter. Tighten all screws evenly.

5.Unit clamp down information. Once unit is installed in counter opening, you must clamp unit down as shown in figure 14.

6.Make electrical connections as outlined in "Electrical Connection" Section.

To clamp down, insert bracket with offset side of angle into slot on each side of unit. The screw should then be run through bracket and against bottom of counter. Tighten until draws down.

CooktopCountertop

Hold down retainer

Screw

 

Hold down retainer

Countertop

Burner box

Figure 12

4.Models: 30" and 36" (36" X 21½") Coil Elements

Cooktops

-These cooktops are designed to fit various cutout sizes.

The minimum and maximum cutout openings are shown in figure 1.

-If cooktop is to be used in new installation, use minimum cutout dimensions in figure 1.

-Attach cooktop to cabinet using wood screws through holes in vertical walls of burner box.

-If cooktop is to be installed as a replacement in an existing countertop opening (not exceeding maximum cutout dimensions as shown in figure 1), the following steps must be taken:

1.Insert 4 screws and installation spacers through holes in vertical walls of burner box (see figure 13).

2.Place cooktop into countertop opening and center unit in cutout.

3.Tighten each screw finger tight or until spacers are snug against burner box walls.

Burner box

Spacer

Screw

Figure 13

Burner box

Figure 14

Checking Operation

Refer to the Owner's Guide for operation.

CAUTION Do not touch cooktop glass or elements. They may be hot enough to burn.

Model and Serial Number Location

The serial plate is located under the cooktop or in the burner box and can be seen by lifting up the main top of unit.

When ordering parts for or making inquires about your cooktop, always be sure to include the model and serial numbers and a lot number or letter from the serial plate on your cooktop.

Before You Call for Service

Read the Avoid Service Checklist and operating instructions in your Owner's Guide. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance.

Refer to the warranty in your Owner's Guide for our service phone number and address. Please call or write if you have inquiries about your product and/or need to order parts.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Model Important INSTALLATION‑INFORMATIONWidth Depth Length Below MIN MAX Important Note to the Consumer Important Notes to the InstallerObserve all governing codes and local ordinances Unpacking InstructionsUnder cooktop Listed Green WireWire Grounded Junction BOX Bare orCSA listed Cable from appliance ConduitModels 26 and 36 36 X 18 Coil Elements Cooktops Cooktop InstallationAll Ceramic-Glass Cooktops Set the cooktop into the countertop cutoutModels 32 Coil Elements Cooktops Before You Call for ServiceChecking Operation Model and Serial Number LocationDepth Height Cutout DimensionsMAX MIN Dimensiones DE RecortadoInformación Importante Para LA Instalación Modelo Longitud AnchuraNota importante al consumidor Notas importantes para el instaladorConexión eléctrica Instrucciones de desembalajeRiesgo DE Descarga Eléctrica La conexión a Riesgo de choque eléctricoCaja DE Empalmes DE 3 Alambres Puesta a Tierra Cable desde el suministro de energía Alambre desnudo Verde oRojos Negros Caja de Empalmes Alambre ve rde Conductor de Desnudo Cable de la estufa CSAEstufa Instalación de la estufaTornillos EspaciadoresModelos 32 con resistencias espirales Revisión de operaciónUbicación del número de modelo y de serie Antes de llamar al servicioCON Tapa DE Cocina Montada Dimensiones DE Abertura Anchura Profundidad AlturaMIN MAX Dimensions DE DécoupageInstructions DE Sécurité Importantes Modèle Longueur LargeurConsommateur InstallateurModèles vitrocéramiques seulement Instructions de déballageFils rouges Boîte de Jonction Fil dénudé Fil blanc Ou vert La mise à la terre de cet appareil est obligatoireFil dénudé Connecteur Ou vert Ou Acnor Câble de lappareilFil dénudé Fils Ou vert RougesBoîte de jonction Canadien norme Acnor C22.1, Partie 1 Figure Installation de la plaque de cuissonModèles de plaque de cuisson 32 avec éléments spiraux Vérification de fonctionnement Emplacement des numéros de modèle et de sériePour retenir le four Encastré à larmoire Dimensions DE Louverture Largeur Profondeur HauteurPour réduire les Risques de blessures

318205403 specifications

The Frigidaire 318205403 is a versatile and efficient oven range component designed to enhance culinary experiences in the modern kitchen. Featuring a sleek design and robust construction, this product is a popular choice for homeowners seeking quality and reliability in their cooking appliances.

One of the main features of the Frigidaire 318205403 is its compatibility with a range of Frigidaire models, making it a convenient replacement part for many users. It is primarily known as a bake element, essential for delivering consistent temperatures and even cooking results. With a power rating that typically hovers around 3,000 watts, this bake element ensures that dishes are cooked thoroughly and evenly, helping home cooks achieve perfectly baked goods.

The technology behind the Frigidaire 318205403 includes advanced heating elements that employ durable materials, designed to withstand high temperatures and frequent usage. This durability translates to a longer lifespan, making it a cost-effective choice for those looking to maintain or repair their existing ovens. Additionally, the element is engineered for easy installation, allowing users to replace their old or malfunctioning parts without requiring professional help.

Another characteristic worth noting is the element's ability to distribute heat evenly across the cooking surface. This uniform heating prevents hot spots, which can often lead to uneven cooking or baking inconsistencies. Whether preparing a delicate soufflé or a robust lasagna, users can rely on the Frigidaire 318205403 to produce reliable results every time.

Furthermore, the Frigidaire 318205403 is designed with safety in mind. It includes features that minimize the risk of overheating, which can pose a hazard in household kitchens. This attention to safety ensures users can cook reliably without the worry of potential accidents.

In conclusion, the Frigidaire 318205403 is a crucial component for any Frigidaire oven range, combining efficiency, durability, and safety. Its features make it an essential part of kitchen operations, ensuring that users can enjoy their cooking experience with confidence. Whether you're a casual home cook or a seasoned chef, the Frigidaire 318205403 is a dependable choice for all your baking needs.
Top Page Image Contents