Electrolux C75301K Operating the Hob, Touch Control Sensor Field, Switching On the Appliance

Page 13

Operating Instructions

Operating the Hob

3	When a cooking zone is switched on, it may hum briefly. This is a char-
	acteristic of all glass ceramic cooking zones and does not impair either

the function or the life of the appliance.

TOUCH CONTROL Sensor Field

To operate the TOUCH CONTROL sensor field place your finger from above flat onto the required field until the appropriate displays come on or go out or the required function is carried out.

Switching On the Appliance

The entire appliance is switched on using the “On/Off” n sensor field. Touch the “On/Off” sensor field for approx. 2 seconds.

The digital displays will show j and the decimal point will flash.

3	Once the “On/Off” sensor field has been operated to switch on the ap-
	pliance, one of the cooking zones must be selected within approx.

10 seconds using the cooking zone selection buttons. Otherwise the ap- pliance switches off again for safety reasons.

49

Image 13

Contents C75301K Dear customer Following symbols are used in the textPlease read these operating instructions carefully Contents Page Electrical Safety SafetyChild Safety Please contact your local customer centre or your dealerSafety When Cleaning Safety During UseSwitch off the cooking zones after use To Avoid damaging your appliance Disposing of the packaging material DisposalInformation on disposal Appliance must not be disposed of with household rubbishKey Features of Your Appliance Description of the hob Cancelling the Safety Cut-out Cooking Zone Safety Cut-outSwitching Off for Other Reasons Digital DisplayInitial Cleaning Before Using for the First TimeWipe the ceramic glass surface with a damp cloth Be damagedOperating the Hob Switching On the ApplianceTouch Control Sensor Field Function or the life of the applianceCooking Zone Selection Switching Off the ApplianceCooking zone is finally switched off Heat Setting Selection +Keep Warm Switching the Casserole Zone On and Off Switching the Triple Ring Cooking Zone On and Off Operating Instructions Stop+Go Function Cooking zone display Switching off a Cooking ZoneIndicator only goes out when the cooking zone is cold Residual Heat IndicatorIs a risk of burns Cooking with the Automatic Warm up Function Switching off a cooking zone Lower setting, the warm up time ends at onceCooking without the Automatic Warm up Function EnergyTimer Ending the timer function prematurely Using the timer to measure short periods of timeDisplaying the remaining cooking time Minute MinderPans Uses, Tables and TipsEnergy saving tips Automatic warm up function is suitable for Advice on Cooking with and without Automatic Warm upAutomatic warm up function is not suitable for General notesAt an appropriate lower heat setting Typical Heat SettingsHob Cleaning and CareLight Soiling Stubborn SoilingHob Frame Problem DirtWhat to do if Rectifying faultsWhat do I do if Cooking zone cannot be switched on? Cooking zone cannot be switched off?Check whether Lock is activated Is shown in the display?Cut-out dimensions Technical Data Appliance dimensionsPower consumption Heating element voltageRegulations, Standards, Directives Safety Instructions for the Installer Tions and the terminal screws tightened securely Electrical ConnectionInstallation Instructions Installation Instructions When do you incur costs even during the warranty period? Is it a technical fault?Assembly 117 Removal 119 Salvo modificaciones