Electrolux C75301K operating instructions Safety Instructions for the Installer

Page 35

Installation Instructions

1Safety Instructions for the Installer

•A device must be provided in the electrical installation which allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm.

Suitable isolation devices include line protecting cut-outs, fuses (screw type fuses are to be removed from the holder), earth leakage trips and contactors.

•In respect of fire protection, this appliance corresponds to type Y (EN 60 335-2-6). Only this type of appliance may be installed with a high cupboard or wall on one side.

•Drawers may not be fitted underneath the hob.

•The installation must guarantee shock protection.

•The kitchen unit in which the appliance is fitted must satisfy the sta- bility requirements of DIN 68930.

•For protection against moisture, all cut surfaces are to be sealed with a suitable sealant.

•On tiled work surfaces, the joints in the area where the hob sits must be completely filled with grout.

•On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in place with a suitable artificial resin or mixed ad- hesive.

•Ensure that the seal is correctly seated in the frame and that it is seated against the work surface without leaving any gaps. Additional silicon sealant must not be applied; this will make removal more dif- ficult when servicing.

•The hob must be pressed out from below when removed.

71

Image 35

Contents C75301K Please read these operating instructions carefully Following symbols are used in the textDear customer Contents Page Please contact your local customer centre or your dealer SafetyElectrical Safety Child SafetySwitch off the cooking zones after use Safety During UseSafety When Cleaning To Avoid damaging your appliance Appliance must not be disposed of with household rubbish DisposalDisposing of the packaging material Information on disposalKey Features of Your Appliance Description of the hob Digital Display Cooking Zone Safety Cut-outCancelling the Safety Cut-out Switching Off for Other ReasonsBe damaged Before Using for the First TimeInitial Cleaning Wipe the ceramic glass surface with a damp clothFunction or the life of the appliance Switching On the ApplianceOperating the Hob Touch Control Sensor FieldCooking Zone Selection Switching Off the ApplianceKeep Warm Heat Setting Selection +Cooking zone is finally switched off Switching the Casserole Zone On and Off Switching the Triple Ring Cooking Zone On and Off Operating Instructions Stop+Go Function Cooking zone display Switching off a Cooking ZoneIs a risk of burns Residual Heat IndicatorIndicator only goes out when the cooking zone is cold Cooking with the Automatic Warm up Function Energy Lower setting, the warm up time ends at onceSwitching off a cooking zone Cooking without the Automatic Warm up FunctionTimer Minute Minder Using the timer to measure short periods of timeEnding the timer function prematurely Displaying the remaining cooking timeEnergy saving tips Uses, Tables and TipsPans General notes Advice on Cooking with and without Automatic Warm upAutomatic warm up function is suitable for Automatic warm up function is not suitable forAt an appropriate lower heat setting Typical Heat SettingsStubborn Soiling Cleaning and CareHob Light SoilingHob Frame Problem DirtWhat do I do if Rectifying faultsWhat to do if Is shown in the display? Cooking zone cannot be switched off?Cooking zone cannot be switched on? Check whether Lock is activatedHeating element voltage Technical Data Appliance dimensionsCut-out dimensions Power consumptionRegulations, Standards, Directives Safety Instructions for the Installer Tions and the terminal screws tightened securely Electrical ConnectionInstallation Instructions Installation Instructions When do you incur costs even during the warranty period? Is it a technical fault?Assembly 117 Removal 119 Salvo modificaciones