INSTALLATION INSTRUCTIONS
WARNINGS
This appliance must be installed by a qualified electrician/competent person. Safety may be impaired if installation is not carried out in accordance with these instructions.
This appliance must be earthed.
Do not remove the screws from the earth tab extending from the oven mains terminal block (Fig. 1).
Before connecting the appliance make sure that the voltage of your electricity supply is the same as that indicated on the rating
plate. This is situated on the lower front | Fig.1 |
frame of the appliance and can be seen upon |
|
opening the door. Alternatively the rating |
|
plate may also be found on the back or top |
|
of some models (where applicable). |
|
Do not alter the electrical circuitry of this appliance.
THINGS TO NOTE
This appliance is designed to be fitted in cabinets of the recommended dimensions as shown (Fig.3).
If your cabinet interior dimension is between 565- 570mm the oven may still be fitted. However, a minor modification to the cabinet will be required to reduce the aperture size down to
The dimensions given provide adequate air circulation around the unit within the cabinet, ensuring compliance with BS
Enquiries regarding the installation of the cooker point, if required, should be made to your Regional Electricity Company to ensure compliance with their regulations.
The appliance socket switch should be outside the cabinet but within 2m of the appliance to make it accessible to switch off the appliance in case of an emergency.
To protect the hands, wear gloves when lifting the oven into its housing.
Do not lift the appliance by the handles.
NOTE: HOUSE CIRCUIT
Earth leakage and continuity tests must be carried out before the appliance is connected to the mains supply and
39