Setting the Clock
The CLOCK @ pad is used to set the clock. The clock may be
set for 12 or 24 hour time of day operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash with "PF" (power failure, See Fig. 1).
INSTRUCTIONS
To set the clock (example below for 1:30):
1.Press @. "CLO" will appear in the display (Fig. 2).
2.Press @@@padstosetthetimeofdaytol:30(Fig.
3). "CLO" wilt appear in the display. Press 'O" "CLO" will
disappear and the clock will start (Fig. 4).
Changing between 12 or 24 hour time of day display:
1.Press and hold @ for 6 seconds (Fig. 3). While holding the
pad down, the current time of day will remain and "CLO" wilt disappear from the display (Fig. 4). CONTINUE holding the pad until the a beep is heard.
2.The display will show either "12:00" (Fig. 5) or "24:00" (Fig. 6).
A
3.Press _1 to switch between the 12 and 24 hour time of day
display. The display will show either "12:00" (Fig. 5) or "24:00" (Fig. 6).
4. Press | I to accept the change or press _ | to reject the |
change.
5.Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was chosen, the clock will now display time from 0:00 through 23:59 hours.
Figure 1
PRESSDISPLAY
Figure 2
Figure 3
for 6 seconds
Figure 4
Figure 5
Figure 6
14