Cooktop cleaning (cont’d)
DO NOT use the following on the cooktop:
•Do not use abrasive cleaners and scouring pads, such as metal and some nylon pads. They may scratch the cooktop, making it more difficult to clean.
•Do not use harsh cleaners, such as chlorine bleach, ammonia or oven cleaners, as they may etch or discolor the cooktop.
•Do not use dirty sponges, cloths or paper towels, as they can leave soil or lint on the cooktop which can burn and cause discoloration.
Aluminum foil and oven liners
WARNING
Protective
Using a liner in the oven will restrict the heat and air flow needed to obtain the best possible cooking results for any oven, including the warmer drawer (some models).
Do not use oven bottom liners or use aluminum foil to cover the oven bottom or any oven racks.
During
CARE & CLEANING
Aluminum foil and oven liners (cont’d)
Aluminum foil and the cooktop - Use of aluminum foil on a hot cooktop can damage the ceramic glass. Do not use thin aluminum cooking utensils or allow aluminum foil to touch the ceramic cooktop under ANY circumstances.
Aluminum utensils and the cooktop - Care must be taken when aluminum pots or pans are used on the cooktop. If aluminum pans are allowed to boil dry when using the cooktop, the utensil be damaged or destroyed, and may fuse to, break or mark the ceramic glass surface, permanently damaging the cooktop surface.
Replacing interior oven light
CAUTION
Be sure the range is unplugged and all parts are COOL before replacing oven light. Wear a
The interior oven light is | glass | |
located at the rear of the | shield | |
oven interior back wall and |
| |
is covered with a glass | wire | |
shield held by a wire | ||
holder | ||
holder. | ||
| ||
The glass shield must |
| |
always be in place to |
| |
protect and shield the oven |
| |
interior light whenever |
| |
using the oven. |
| |
To replace the oven light bulb: |
1.Turn electrical power off at the main source or unplug the range.
2.While holding the glass shield in place, press wire holder to one side to release the glass shield.
3.Remove glass shield. Replace bulb with a new 40 watt appliance bulb.
4.Replace glass shield over bulb and snap wire holder into place.
5.Turn power back on again at the main source (or plug the range back in).
6.The clock will then need to be reset. To reset, see Setting the Clock and Minute Timer in this Use & Care Manual.
27