Frigidaire 318200710 Changing Cooktop and/ or Oven Lights, Extended guides

To Remove and Replace Storage Drawer (with

extended guides)

Figure 1

Figure 2

To Remove Storage Drawer:

1.Open the drawer to the fully opened position.

2.Locate the glide lever on each side of drawer; pull up on the left glide lever and push down on the right glide lever (see figure 1).

3.Pull the drawer away from the range.

To Replace Storage Drawer:

1.Pull the bearing glides to the front of the range (see figure 2).

2.Align the drawer glides with the slots on the bearing glides.

3.Push the drawer into the range until the glides levers “click” (approx. 2 in.). Pull the drawer open again to seat it into position.

4.If you do not hear the glide levers “click” or if the drawer does not feel seated, remove it and repeat steps 1 through 3. Doing so will minimize damage to the bearing glides. Do not try to force the drawer into place.

Changing Cooktop and/ or Oven Lights

(some models)

To Change the Cooktop Light (some models)

Your model will either have a canopy cover that lifts up or 2 Phillips® Head screws that secure the light cover. BEFORE CHANGING THE COOKTOP LIGHT, BE SURE TO TURN THE POWER OFF AT THE MAIN SOURCE OR UNPLUG THE RANGE.

For models with a canopy cover that lifts up, follow these instructions:

1.Grasp the front edge of the canopy cover as illustrated in the side column. Pull forward and lift the cover up and off toward rear of range.

2.Remove bulb by rolling up and out. Install the new bulb by sliding down into place and rolling toward front of range.

3.Align front edge of light cover with inside lip of end cap. Lower rear of cover into place and snap down.

4.Turn power back on at the main source (or plug the range back in).

To Change the Oven Light

The oven light automatically turns on when the door is opened (some models). To turn the oven light on and off when the door is closed, use the OVEN LIGHT switch located on the control panel.

1.Turn electrical power off at the main source or unplug the oven.

2.Wear a leather-faced glove for protection against possible broken glass.

3.Press wire holder to one side to release the glass shield.

4.Replace bulb with a new 40 watt appliance bulb.

5.Replace glass shield in socket and snap wire holder into place.

6.Turn power back on at the main source (or plug the appliance back in).

7.The clock will then need to be reset. To reset, see Setting the Clock and Minute Timer in the ELECTRONIC OVEN CONTROL manual.

Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven light on during a self-cleaning cycle. High temperature will reduce lamp life.

23