Frigidaire 318200710 Indicator Lights, For models with Ceramic Glass Cooktop

Page 9

Setting Surface Controls

(continued)

Expandable & Bridge Radiant

Element Control Dial

Knob may look different

Ceramic Glass Cooktop (some models) (continued)

EXPANDABLE RADIANT HEATING UNITS (some models)

This heating unit adapts to both small and large heating utensils. The unit control dial has a dual set of graduations. For small utensils use the left side of the control dial; for large utensils the right. Only the inner surface of the unit heats when using it for small utensils; the whole surface heats for large utensils. The hot surface and surface indicator lights will glow when the heating unit is turned ON.

Note: During any heat setting of the outer radiant element, the inner radiant ele- ment cycles on and off with the outer element.

BRIDGE RADIANT HEATING UNITS (some models)

Its principal advantage is to allow you to create larger cooking zone for larger pan suchs as roaster, griddle or some other specialty pans.

To use the bridge element, turn the control knob on right side, to the bridge burner graduations.

For full bridge element operation turn on the left rear burner.

To use only the front element, turn the control knob on left side, to the front burner graduations.

Indicator Lights

(for models with Ceramic Glass Cooktop)

Two different surface control lights will glow on your range: Surface Indicator Lights and Hot Surface Indicator Lights.

The surface indicator lights, located on the control panel, glow when any surface unit is turned on. A quick glance at the lights after cooking is an easy check to be sure all surface controls are turned off.

The hot surface indicators lights, located under the glass cooktop, will come on as the surface cooking area heats up and will continue to glow until the glass cooktop has cooled down to a moderate level. The lights may remain on even though the controls are turned to OFF.

9

Image 9
Contents Range Register Your Product Product RegistrationVersión en español Record Your Model and Serial NumbersImportant Safety Instructions Do Not Immerse or Soak Removable Heating Know which knob controls each surface heating unitFor Glass Cooktops only Cookshop or hardware stores Selecting Surface Cooking UtensilsSetting Type of cooking Setting Surface Controls To Operate the Surface ElementCanning Tips Information Prevent damage to cooktopApproximate Griddle Settings Setting Surface ControlsTo Operate the Griddle If equipped Ceramic Glass Cooktop some modelsFor models with Ceramic Glass Cooktop Indicator LightsExpandable Radiant Heating Units some models Bridge Radiant Heating Units some modelsIndicator Lights Temperature SelectionTo Set the Warmer Zone Control Some modelsAir Circulation in the Oven Oven Vents and RacksOvens Vents Locations For Ceramic Glass Cooktops Models Ovens Vents Locations For Coil Elements ModelsBottom Oven Baking Informa- tionsPreheating Broiling InformationsTo Broil Determining Broiling TimesConvection Roasting Convection CookingBaking If equipped If equippedSetting Side Oven Control Left oven, if equippedTo Bake Adhere to the Following Precautions Self-Clean Oven CyclePreparing for the Self-Cleaning Cycle What to Expect During CleaningGeneral Cleaning Cleaning Side Oven If equippedTo Clean the Oven Bottom Porcelain Enamel OvenThings to Remember To Clean the Cooktop GlassUse and Care of Glass Surface Aluminum foilTo Clean the Cooktop GlassRemoval Cleaning Various Parts of Your Range VinylStainless Steel To Clean Drip Bowls To Raise the Top for Cleaning Some Models OnlySurface Elements and Drip Bowls To Replace Drip Bowls and Surface ElementsStorage Drawer Cleaning the Griddle some modelsNot immerse griddle terminals in water To Remove the Storage DrawerExtended guides Changing Cooktop and/ or Oven LightsSome models To Change the Cooktop Light some models To Change the Oven LightIs not caused by defective product workmanship or materials Avoid Service ChecklistAreas of discoloration with metallic Page Page Major Appliance Warranty Information