DeLonghi DEGLSC24SS Important Notes, Self Cleaning Function this is not a cooking function

Page 14

NEVER USE THE RANGE WHEN THE OVEN IS OPERATING IN SELF CLEANING MODE.

CAUTION: During the self clean- ing cycle the accessible parts may become hot. Keep children away.

IMPORTANT:

The health of some birds is extremely sensitive to the fumes given off during the self-cleaning cycle.

Exposure to the fumes may result in death to certain birds.

Always move birds to another closed and well ventilated room.

SELF CLEANING FUNCTION (this is not a cooking function)

IMPORTANT NOTES:

This is not a cooking function but is only used to clean the oven.

Before starting the self cleaning cycle:

-Take all the accessories out of the oven (drip tray and shelves).

-Clean any traces of liquid which have overflowed.

-Close the oven door and make sure that it is closed properly.

If there are cracks or flaws on the oven door glass (inside/outside) or if the gaskets are ruined or worn or if the door does not close perfectly, unplug the appliance and contact the Service Centre.

GENERAL INFORMATION

In this function the residual cooking greases on the inside walls of the oven cavity are pulverised by the high temperature. The fumes produced during this process are fil- tered by a special catalyst in the upper part of the appliance.

Smells and fumes produced during self cleaning are not a cause of alarm. Adequate ventilation should however be provided in the room where the range is installed, e.g. by opening a window.

Do not wait for the oven to be very greasy before performing this cleaning. It should not be performed after every cooking, either, but only when the level of dirt justifies it (on average 1 – 2 times a month depending on oven use).

For safety reasons (high temperature of the oven cavity), when the self cleaning starts the oven door is automatically locked by an electronic device (after about 30 seconds on the control panel the door locked pilot light lights up). The door can no longer be opened and is only unlocked at the end of the cleaning cycle or, stopping the cycle, when the oven cavity has cooled to a temperature lower than 570 °F (300 °C).

When the self cleaning function starts an internal fan starts automatically to cool the oven walls. It only stops at the end of the cycle, when the oven cavity temperature has dropped below 212 °F (100 °C).

The procedures for starting, stopping and completing the self cleaning cycle and deal- ing with any problems are described in the following chapters:

-“How to start the self cleaning cycle”

-“Problems on starting and during the self cleaning cycle”

-“How to stop the self cleaning cycle”

-“What to do when the self cleaning cycle has finished”

-“Abnormal situations and/or operating problems”

IMPORTANT:

DURING THE SELF-CLEANING CYCLE THE VITROCERAMIC HOB COOKING ZONES DO NOT OPER- ATE.

If during self-cleaning cycle a cooking zone control knob has been turned ON return the knob to the OFF position. Otherwise at the end of the self-cleaning cycle and after having turned the oven selector control knob to the OFF position, the cooking zone will operate.

WHEN THE SELF CLEANING MODE HAS BEEN COMPLETED:

do not start immediately a new self cleaning cycle on the same oven: LET THE RANGE TO COOL DOWN.

IMPORTANT:

DURING THE SELF-CLEANING CYCLE THE WARMING DRAWER DO NOT OPERATES.

If during self-cleaning cycle the warming drawer control knob has been turned ON return the knob to the OFF position. Otherwise at the end of the self-cleaning cycle and after having turned the oven selector control knob to the OFF position, the warming drawer will operates.

14

Image 14
Contents Electric Range ALL Ranges can TIP Dear Customer Electrical Requirement Replacement PartsElectrical Grounding Instructions Important Precautions and Recommendations Never obstruct the slots on the backguard FeaturesVitroceramic Cooking HOB Control PanelCooking Zones How to use the vitroceramic hobVitroceramic HOB Double Cooking Zone Rear left zoneHints for Safe USE of the Hobs Cooking Zones Power Indicator Light figCooking Zones Residual Heat Indicator Using the Warming Drawer for the First Time How to use the warmer drawerGeneral Features To USE the Warming DrawerTemperature Selector Between LO and HIHow to use the self cleaning oven Using the Oven for the First TimeDefrosting Frozen Foods this is not a cooking function Selecting the Functions figOven Light this is not a cooking function Traditional Convection Cooking Self Cleaning Function this is not a cooking function Important NotesTurn the selector knob to the cooking function required Selecting F/C on the DisplayTurn the oven selector knob to a cooking function i.e. Bake HOW to Start the Self Cleaning Cycle Press pushbutton 3 on the programmer to start the cycleDoor with Auto flashing Problems on Starting and During the Self Cleaning CycleSteady door F0.00 with Auto flashingTurn the function selector to OFF oven OFF HOW to Stop the Self Cleaning CycleWhat to do When the Self Cleaning Cycle has Finished Function selector has been turned to any cooking functionF0.00 appears during the self cleaning cycle Abnormal Situations AND/OR Operation ProblemsDuring cooking or the self cleaning cycle Roasting Cooking Advice SterilizationRegeneration Cooking Different Dishes AT the Same TimeStep Broiling Audible Signal How to use the electronic programmerSetting the Time Description of the light symbolsSEMI-AUTOMATIC Cooking TimerSetting During cookingAutomatic Cooking Starting cookingCancelling a SET Programme Examples of Programming Automatic CookingCleaning and maintenance Oven Shelf Installation and Removal Replacing the Oven Light figRemoving the Warmer Drawer fig Fitting the Warmer Drawer figRemoving the Oven Door For Your Safety DO’S and do NOT’SPage Cod ß3