DeLonghi DEGLSC24SS warranty Automatic Cooking, Starting cooking

Page 24

I

I

I

 

I

I

 

I

I

 

I

I

 

I

 

I

I

I

 

I

I

I

I

I

I

I

 

I

I

 

II

2

5

6

I

I

I

I

I

I

I

 

I

I

 

II

3

5

6

I

I

I

I

I

I

I

I

I

 

II

24

AUTOMATIC COOKING

Start cooking at the programmed time and switch the oven off automatically after the programmed cooking time.

Setting

1.Set the cooking function by turning the oven selector to the function required.

2.The cooking temperature appears on the display. To change it proceed as described in the Setting the cooking chapter.

3.Press pushbutton 2. AUTO starts to flash and 0.00 appears.

4.Press pushbuttons 5 or 6 to set the cooking time (cooking time in hours and min- utes: set it to ten minutes less than the time required because the stored heat will complete the cooking).

5.On the display AUTO becomes steady and the cooking programme starts.

6.Press pushbutton 3 (AUTO starts to flash).

7.Press pushbuttons 5 or 6 to set the time when the cooking should finish.

The values set must be correct; e.g. if it is 08:00 a cooking time of 3 hours, ending at 10:00, cannot be set. In this case the programmer automatically sets the end of cooking time for 11:00.

8.On the display AUTO becomes steady and the time appears again. The cooking symbol goes out.

Starting cooking

9.The pan symbol lights up. The oven switches on and the cooking cycle set starts.

During cooking

10.During the cooking cycle, the display shows the oven temperature measured by the probe or pre-setted temperature.

Press key 2 to display the length of cooking set. Press key 3 to display when the cooking will finish.

The cooking time, end of cooking time and cooking temperature can be varied at any time, as described above.

At the end of cooking

11.End appears on the display, AUTO flashes and the audible signal sounds. The cooking cycle has finished and the oven is OFF.

13.Press any pushbutton to stop the audible signal.

14.OFF appears (oven OFF).

15.Turn the function selector to OFF (oven OFF).

16.The programmer display shows the time.

Note: At the end of the programme always turn the function selector knob to OFF (oven OFF).

IMPORTANT: During AUTOMATIC COOKING PROGRAM the oven light is always on, also before starting (heating elements on or cycling) of the programmed cooking.

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Electric Range ALL Ranges can TIP Dear Customer Replacement Parts Electrical Grounding InstructionsElectrical Requirement Important Precautions and Recommendations Features Vitroceramic Cooking HOBNever obstruct the slots on the backguard Control PanelHow to use the vitroceramic hob Vitroceramic HOBCooking Zones Double Cooking Zone Rear left zoneCooking Zones Power Indicator Light fig Cooking Zones Residual Heat IndicatorHints for Safe USE of the Hobs How to use the warmer drawer General FeaturesUsing the Warming Drawer for the First Time To USE the Warming DrawerTemperature Selector Between LO and HIHow to use the self cleaning oven Using the Oven for the First TimeSelecting the Functions fig Oven Light this is not a cooking functionDefrosting Frozen Foods this is not a cooking function Traditional Convection Cooking Self Cleaning Function this is not a cooking function Important NotesSelecting F/C on the Display Turn the oven selector knob to a cooking function i.e. BakeTurn the selector knob to the cooking function required HOW to Start the Self Cleaning Cycle Press pushbutton 3 on the programmer to start the cycleProblems on Starting and During the Self Cleaning Cycle Steady doorDoor with Auto flashing F0.00 with Auto flashingHOW to Stop the Self Cleaning Cycle What to do When the Self Cleaning Cycle has FinishedTurn the function selector to OFF oven OFF Function selector has been turned to any cooking functionAbnormal Situations AND/OR Operation Problems During cooking or the self cleaning cycleF0.00 appears during the self cleaning cycle Cooking Advice Sterilization RegenerationRoasting Cooking Different Dishes AT the Same TimeStep Broiling How to use the electronic programmer Setting the TimeAudible Signal Description of the light symbolsTimer SettingSEMI-AUTOMATIC Cooking During cookingAutomatic Cooking Starting cookingCancelling a SET Programme Examples of Programming Automatic CookingCleaning and maintenance Oven Shelf Installation and Removal Replacing the Oven Light figRemoving the Warmer Drawer fig Fitting the Warmer Drawer figRemoving the Oven Door For Your Safety DO’S and do NOT’SPage Cod ß3
Top Page Image Contents