GE JB720, JB730 Troubleshooting, Using the Warming Zone, Temperature Limiter, Home Canning Tips

Page 8

Instructions

Using the surface units.

Throughout this manual, features and appearance may vary from your model.

Cleaning Operating Instructions Safety

WARMER GUIDE

SETTING

FOOD

(Low)

Bread/Pastries

(Medium)

Chocolate/Butter

(Medium)

Sauces, Stews,

 

Cream Soups

(Medium)

Vegetables

(High)

Soups (liquid)

(High)

Tea or Coffee

The Warmer Guide is for reference only and the SETTING that you need will depend on the amount and type of food, the starting temperature of the food and the length of the holding time.

Using the Warming Zone

The WARMING ZONE, located in the back center of the glass surface, will keep hot, cooked food at serving temperature. Always start with hot food. Do not use to heat cold food. Placing uncooked or cold food on the WARMING ZONE could result in food-borne illness.

Push and turn the control knob to any desired setting.

For best results, all foods on the

WARMING ZONE should be covered with a lid or aluminum foil. When warming pastries or breads, the cover should be vented to allow moisture to escape.

Always use pot holders or oven mitts when removing food from the WARMING ZONE, since cookware and plates will be hot.

CAUTION: Do not warm food on the WARMING ZONE for more than two hours.

NOTE: The surface warmer will not glow red like the cooking elements.

A HOT surface indicator light will glow when the glass surface is hot and will remain on until the surface is cool enough to touch. Lower settings may not heat the glass surface enough to cause the HOT surface indicator light to come on.

A WARMING ZONE indicator light will glow when the unit is on.

Do not use plastic wrap to cover food. Plastic may melt onto the surface and be very difficult to clean.

Use only cookware recommended for top-of-range cooking.

Temperature Limiter

Care and

Every radiant surface unit has a temperature limiter.

The temperature limiter protects the glass cooktop from getting too hot.

The temperature limiter may cycle the units off for a time if:

The pan boils dry.

The pan bottom is not flat.

The pan is off-center.

There is no pan on the unit.

Tips

Home Canning Tips

Troubleshooting

Be sure the canner is centered over the surface unit.

Make sure the canner is flat on the bottom.

To prevent burns from steam or heat, use caution when canning.

Use recipes and procedures from reputable sources. These are available from manufacturers such as Ball® and Kerr® and the Department of Agriculture Extension Service.

Flat-bottomed canners are recommended. Use of water bath canners with rippled bottoms may extend the time required to bring the water to a boil.

Consumer Support

Wok Cooking

We recommend that you use only a flat-bottomed

Do not use round bottom woks.

wok. They are available at your local retail store.

You could be seriously burned if the

Do not use woks that have support rings.

wok tipped over.

 

Use only flat-bottomed woks.

8

Image 8
Contents RangesSelf-Cleaning Radiant Write the model and serial numbers here Model # Serial #Important Safety Notice All ranges can tip and injury could resultTroubleshooting Tips Consumer Support Ge.comCleaning Operating Instructions Safety Troubleshooting Tips CareRadiant Surface Units Oven Operating InstructionsUsing the surface units SafetyOperating Instructions Care and Cleaning Troubleshooting Tips Consumer SupportTroubleshooting Using the Warming ZoneTemperature Limiter Home Canning TipsSelecting types of cookware Using the oven controls Oven Control, Clock and Timer Features and SettingsPower Outage Power failure. Reset the clockHow to Set the Oven for Baking or Roasting Preheating and Pan PlacementInstructions Before you begin…Care and Cleaning Troubleshooting Tips Consumer Support How to Set the Upper Oven for BroilingBroiling Guide 4 Pass Broil Element Broiling GuideUsing the oven Broiling Guide 6 Pass Broil ElementUsing the clock and timer Cleaning Troubleshooting TipsConsumer CareCare How to Set an Immediate Start and Automatic StopHow to Set a Delayed Start and Automatic Stop Special features of your oven control Hour Shut-OffHow to Set Sabbath Feature for Regular Baking/Roasting Using the Sabbath FeatureConsumer Support Troubleshooting Tips How to Exit the Sabbath Feature SafetyType of margarine will affect baking performance Adjust the oven thermostat-Do it yourselfTo Adjust the Thermostat Using the warming drawer. on some models When Using the Warming DrawerTo Use the Warming Drawer Instructions OperatingConsumer Support Troubleshooting Tips Care and Cleaning Temperature Selection ChartTo Crisp Stale Items To Warm Serving Bowls and PlatesUsing the self-cleaning oven Cleaning Troubleshooting Tips Consumer SupportBefore a Clean Cycle SafetyVinegar and water mixture After a Clean CycleHow to Delay the Start of Cleaning Care and cleaning of the range How to Remove Protective Shipping Film and Packaging TapeOperating Instructions Control KnobsLift-Off Oven Door Painted SurfacesControl Panel Instructions Operating Oven ShelvesStainless Steel Surfaces on some models Removable Warming Drawer PanConsumer Support Troubleshooting Tips Care Oven Light ReplacementInstructions Safety Storage Drawer Removal on some modelsCleaning the glass cooktop Normal Daily Use CleaningInstructions Operating Instructions Burned-On ResidueOperating Instructions Safety Metal Marks and ScratchesCooktop Seal Damage from Sugary Spills and Melted PlasticBefore You Call For Service… Problem Possible Causes What To DoClock and timer do See the Using the clock and timer sectionRemoval instructions in the Care and cleaning Not workDuring a clean cycle Unlock Oven not clean afterClean cycle Won’t closePower outage A numberOr letter flash DisplayWe’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Ge.com Accessories Looking For Something More?GE Electric Range Warranty Safety Instructions Operating InstructionsGE Will Provide What GE Will Not CoverSchedule Service Parts and AccessoriesConsumer Support GE Appliances Website Real Life Design Studio