GE JBP72, JB710, EER3001, JBP81, JBP71 Painted Surfaces, Control Panel, Lift-Off Oven Door

Page 24

Safety Instructions

Care and cleaning of the range.

Painted Surfaces

Painted surfaces include the sides of the

Do not use commercial oven cleaners,

range and the door, top of control panel

cleaning powders, steel wool or harsh

and the drawer front. Clean these with soap

abrasives on any painted surface.

and water or a vinegar and water solution.

 

 

 

Instructions

Control Panel

It’s a good idea to wipe the control panel after each use of the oven. Use a damp cloth to clean or rinse. For cleaning, use mild soap and water or a 50/50 solution of vinegar and water. For rinsing, use clean water. Polish dry with a soft cloth.

Do not use abrasive cleansers, strong liquid cleaners, plastic scouring pads or oven cleaners on the control panel— they will damage the finish.

Consumer Support Troubleshooting Tips Care and Cleaning Operating

Slot

Hinge lock

Pull hinge locks down to unlock.

Removal position

The gasket is designed with a gap at the bottom to allow for proper air circulation.

Do not rub or clean the door gasket—it has an extremely low resistance to abrasion.

If you notice the gasket becoming worn, frayed or damaged in any way or if it has become displaced on the door, you should have it replaced.

24

Lift-Off Oven Door

The door is very heavy. Be careful when removing and lifting the door.

Do not lift the door by the handle.

To remove the door:

Fully open the door.

Pull the hinge locks down toward the door frame, to the unlocked position. A tool, such as a small flat- blade screwdriver, may be required.

Firmly grasp both sides of the door at the top.

Close door to the door removal position, which is halfway between the broil stop position and fully closed.

Lift door up and out until the hinge arm is clear of the slot.

To replace the door:

Firmly grasp both sides of the door at the top.

With the

Bottom

Hinge arm

door at the

edge

 

same angle as

of slot

 

the removal

 

 

position, seat the

 

indentation of

 

Indentation

the hinge arm

 

 

 

into the bottom

 

edge of the hinge slot. The notch in

the hinge arm must be fully seated

into the bottom of the slot.

Fully open the door. If the door will not fully open, the indentation is not seated correctly in the bottom edge of the slot.

Push the hinge locks up against the front frame of the oven cavity to the locked position.

Hinge lock

Hinge arm

Push hinge locks up to lock.

Close the oven door.

To clean the inside of the door:

Do not allow excess water to run into any holes or slots in the door.

Because the area inside the gasket is cleaned during the self-clean cycle, you do not need to clean this by hand.

The area outside the gasket and the door liner can be cleaned with a soap-filled plastic pad, hot water and detergent. Rinse well with a vinegar and water solution.

To clean the outside of the door:

Use soap and water to thoroughly clean the top, sides and front of the oven door. Rinse well. You may also use a glass cleaner to clean the glass on the outside of the door. Do not let water drip into the vent openings.

If any stain on the door vent trim is persistent, use a soft abrasive cleaner and a sponge-scrubber for best results.

Spillage of marinades, fruit juices, tomato sauces and basting materials containing acids may cause discoloration and should be wiped up immediately. When surface is cool, clean and rinse.

Do not use oven cleaners, cleaning powders or harsh abrasives on the outside of the door.

Image 24
Contents RangesSelf-Cleaning Radiant Write the model and serial numbers here Model # Serial #Important Safety Notice All ranges can tip and injury could resultSafety Precautions Ge.comCleaning Operating Instructions Safety Consumer SupportRadiant Surface Units Oven Using the surface units CleaningHow to Set Using the Warming ZoneCleaning Operating Temperature LimiterInstructions Home Canning TipsSafety Troubleshooting Tips Consumer SupportSelecting types of cookware Using the oven controls Oven Control, Clock and Timer Features and SettingsCare and Cleaning Troubleshooting Tips Consumer Support Power OutageUsing the oven How to Set the Oven for Broiling Broiling GuideHI Broil Broil HI/LO pad againUsing the clock and timer How to Set an Immediate Start and Automatic Stop How to Set a Delayed Start and Automatic StopSpecial features of your oven control Safety InstructionsHour Shut-Off Using the Sabbath Feature Operating Instructions Care and CleaningTo Adjust the Thermostat How to Exit the Sabbath FeatureType of margarine will affect baking performance Using the warming drawer. on some models When Using the Warming DrawerTo Use the Warming Drawer Instructions OperatingTemperature Selection Chart To Crisp Stale ItemsTo Warm Serving Bowls and Plates Using the self-cleaning oven Before a Clean CycleSafety How to Set the Oven for CleaningConsumer Support Troubleshooting Tips After a Clean CycleHow to Delay the Start of Cleaning Care and cleaning of the range How to Remove Protective Shipping Film and Packaging TapeControl Knobs Oven VentPainted Surfaces Control PanelLift-Off Oven Door Oven Shelves Stainless Steel Surfaces on some modelsRemovable Warming Drawer Pan Do not use a steel wool pad it will scratch the surfaceOven Light Replacement Instructions SafetyStorage Drawer Removal on some models Oven Heating ElementsCleaning the glass cooktop Normal Daily Use CleaningBurned-On Residue Heavy, Burned-On ResidueMetal Marks and Scratches Cooktop SealDamage from Sugary Spills and Melted Plastic To Order PartsBefore You Call For Service… Problem Possible Causes What To DoClock and timer do See the Using the clock and timer sectionRemoval instructions in the Care and cleaning Not workDuring a clean cycle Unlock Oven not clean afterClean cycle Won’t closePower outage A numberOr letter flash DisplayWe’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Ge.com Consumer Support Troubleshooting Tips Care and Cleaning Ge.com Accessories Looking For Something More?GE Electric Range Warranty Cleaning Troubleshooting Tips Consumer SupportCare GE Will ProvideSchedule Service Parts and AccessoriesConsumer Support GE Appliances Website Real Life Design Studio

JBP72, JBP71, JBP81, EER3001, JB710 specifications

General Electric (GE) has long been a trusted name in kitchen appliances, particularly in the realm of cooking technologies. Among their standout offerings are the GE JB710, EER3001, JBP81, JBP71, and JBP72 models. Each of these models showcases innovative features, reliability, and advanced cooking technologies designed to enhance the culinary experience.

The GE JB710 is a standout model that features a sleek design combined with advanced technology. One of its remarkable features is the oven's true convection, which ensures even baking results by providing consistent heat distribution. Additionally, it boasts self-cleaning capabilities that save time and effort in maintenance. With a smooth surface cooktop that includes five burners, the JB710 offers versatility for multiple cooking tasks simultaneously. The model also incorporates the Precise Air convection system, promoting better cooking results for enthusiasts seeking precision.

The EER3001 is an electric range that takes cooking efficiency to the next level. Its notable features include a dual oven, allowing users to prepare multiple dishes at different temperatures simultaneously. This feature is particularly beneficial during holiday cooking or large family gatherings. The EER3001 also emphasizes energy efficiency with an environmentally friendly design, making it both a practical and eco-conscious choice for modern kitchens.

Shifting focus to the JBP81, this model is known for its durability and ease of use. With a traditional oven format and four surface burners, it combines classic design with reliable performance. The JBP81 includes an oven light for convenient monitoring during baking, along with a manual clean option for straightforward maintenance. It is especially popular among home cooks who appreciate simplicity without compromising quality.

The JBP71 and JBP72 models take versatility one step further, offering various configurations to cater to diverse kitchen layouts and cooking preferences. Both models are equipped with a range of features, such as sealed burners that provide precise heat control and an easy-to-clean surface. They also prioritize safety with features like a child lock system and a hot surface indicator, ensuring peace of mind for families.

In summary, GE's JB710, EER3001, JBP81, JBP71, and JBP72 ranges showcase a perfect blend of technology, convenience, and functionality. Each model serves to enhance the cooking experience, providing users with the tools they need to create culinary masterpieces. With their innovative features and commitment to quality, GE continues to be a leader in the kitchen appliance market, making these models highly sought after by cooks of all levels.