GE JBP81, JB710, EER3001 Cleaning the glass cooktop, Normal Daily Use Cleaning, Burned-On Residue

Page 27

Cleaning the glass cooktop.

ge.com

Safety

Clean your cooktop after each spill. Use CERAMA BRYTE® Ceramic Cooktop Cleaner.

Normal Daily Use Cleaning

ONLY use CERAMA BRYTE® Ceramic Cooktop Cleaner on the glass cooktop. Other creams may not be as effective.

To maintain and protect the surface of your glass cooktop, follow these steps:

Before using the cooktop for the first time, clean it with CERAMA BRYTE® Ceramic Cooktop Cleaner. This helps protect the top and makes cleanup easier.

Daily use of CERAMA BRYTE® Ceramic Cooktop Cleaner will help keep the cooktop looking new.

Shake the cleaning cream well. Apply a few drops of CERAMA BRYTE® Ceramic Cooktop Cleaner directly to the cooktop.

Use a paper towel or CERAMA BRYTE® Cleaning Pad for Ceramic Cooktops to clean the entire cooktop surface.

Use a dry cloth or paper towel to remove all cleaning residue. No need to rinse.

NOTE: It is very important that you DO NOT heat the cooktop until it has been cleaned thoroughly.

Instructions Operating Instructions

Use a CERAMA BRYTE® Cleaning Pad for Ceramic Cooktops.

Burned-On Residue

WARNING: DAMAGE to your glass surface may occur if you use scrub pads other than those recommended.

Allow the cooktop to cool.

Spread a few drops of CERAMA BRYTE® Ceramic Cooktop Cleaner on the entire burned residue area.

Using the included CERAMA BRYTE® Cleaning Pad for Ceramic Cooktops, rub the residue area, applying pressure as needed.

If any residue remains, repeat the steps listed above as needed.

For additional protection, after all residue has been removed, polish the entire surface with CERAMA BRYTE® Ceramic Cooktop Cleaner and a paper towel.

Care and Cleaning

The CERAMA BRYTE® Ceramic Cooktop Scraper and all recommended supplies are available through our Parts Center. See instructions under “To Order Parts” section on next page.

NOTE: Do not use a dull or nicked blade.

Heavy, Burned-On Residue

Allow the cooktop to cool.

Use a single-edge razor blade scraper at approximately a 45° angle against the glass surface and scrape the soil. It will be necessary to apply pressure to the razor scraper in order to remove the residue.

After scraping with the razor scraper, spread a few drops of CERAMA BRYTE® Ceramic Cooktop Cleaner on the entire burned residue area. Use the CERAMA BRYTE® Cleaning Pad to remove any remaining residue.

For additional protection, after all residue has been removed, polish the entire surface with CERAMA BRYTE® Ceramic Cooktop Cleaner and a paper towel.

Troubleshooting Tips Consumer Support

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents Write the model and serial numbers here Model # Serial # RangesSelf-Cleaning RadiantAll ranges can tip and injury could result Important Safety NoticeGe.com Safety PrecautionsConsumer Support Cleaning Operating Instructions SafetyRadiant Surface Units Oven Using the Warming Zone Using the surface unitsCleaning How to SetHome Canning Tips Cleaning OperatingTemperature Limiter InstructionsSafety Troubleshooting Tips Consumer SupportSelecting types of cookware Oven Control, Clock and Timer Features and Settings Using the oven controlsPower Outage Care and Cleaning Troubleshooting Tips Consumer SupportUsing the oven Broil HI/LO pad again How to Set the Oven for BroilingBroiling Guide HI BroilUsing the clock and timer How to Set a Delayed Start and Automatic Stop How to Set an Immediate Start and Automatic StopSpecial features of your oven control Safety InstructionsHour Shut-Off Operating Instructions Care and Cleaning Using the Sabbath FeatureTo Adjust the Thermostat How to Exit the Sabbath FeatureType of margarine will affect baking performance Instructions Operating Using the warming drawer. on some modelsWhen Using the Warming Drawer To Use the Warming DrawerTemperature Selection Chart To Crisp Stale ItemsTo Warm Serving Bowls and Plates How to Set the Oven for Cleaning Using the self-cleaning ovenBefore a Clean Cycle SafetyConsumer Support Troubleshooting Tips After a Clean CycleHow to Delay the Start of Cleaning Oven Vent Care and cleaning of the rangeHow to Remove Protective Shipping Film and Packaging Tape Control Knobs Painted Surfaces Control Panel Lift-Off Oven Door Do not use a steel wool pad it will scratch the surface Oven ShelvesStainless Steel Surfaces on some models Removable Warming Drawer PanOven Heating Elements Oven Light ReplacementInstructions Safety Storage Drawer Removal on some modelsHeavy, Burned-On Residue Cleaning the glass cooktopNormal Daily Use Cleaning Burned-On ResidueTo Order Parts Metal Marks and ScratchesCooktop Seal Damage from Sugary Spills and Melted PlasticProblem Possible Causes What To Do Before You Call For Service…Not work Clock and timer doSee the Using the clock and timer section Removal instructions in the Care and cleaningWon’t close During a clean cycleUnlock Oven not clean after Clean cycleDisplay Power outageA number Or letter flashWe’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Ge.com Consumer Support Troubleshooting Tips Care and Cleaning Ge.com Looking For Something More? AccessoriesGE Will Provide GE Electric Range WarrantyCleaning Troubleshooting Tips Consumer Support CareReal Life Design Studio Schedule ServiceParts and Accessories Consumer Support GE Appliances Website
Top Page Image Contents