Sherwood R-771 manual Remote Control Operation Range, Loading Batteries, English

OPERATING COMPONENTS WITH REMOTE CONTROL

Enter the setup code for each

1 component other than this receiver. For details, refer to "Entering a setup code" on page 18.

Turn on the component you want to

2 operate.

Press the DEVICE button on the

3 remote control corresponding to the component you wish to operate.

Aim the remote control at the REMOTE

4 SENSOR of the component you wish to control and press the button corresponding to the operation you want.

•When operating a Sherwood CD player or tape deck using digi link system remote control, aim the remote control at the REMOTE SENSOR of this receiver.

However, to operate a Sherwood DVD player, aim at the REMOTE SENSOR of the corresponding component.

REMOTE CONTROL OPERATION RANGE

•Use the remote control unit within a range of about 7 meters (23 feet) and angles of up to 30 degrees aiming at the remote sensor.

ENGLISH

LOADING BATTERIES

•When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within several minutes after removing old batteries.

•If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared. Should this happen, you should memorize them again.

1	Remove the cover.	2	Load two batteries("AAA" size)
			matching the polarity.

• Remove the batteries when they are not used for a long time.

• Do not use the rechargeable batteries(Ni-Cd type).

• Be sure to use alkaline batteries.

17