ENGLISH
Continued
Press the CURSOR LEFT( )/ RIGHT( buttons to set the selected speaker as desired.
3
• Depending on your speaker type, you can select one of these following speaker types.
LARGE: Select this when connecting speakers that can fully reproduce sounds below crossover frequency.
SMALL: Select this when connecting speakers that can not fully reproduce sounds below crossover frequency. When this is selected, sounds below crossover frequency are sent to the subwoofer or speakers which are set to LARGE(when not using a subwoofer)
NONE: Select this when no speakers are connected. When this is selected,
sounds are sent to the speakers which are not set to NONE. 2CH/1CH: Select the desired depending on the number of surround back
speakers.
YES/NONE: Select the desired depending on whether a subwoofer is connected or not.
Notes :
•When speakers are set to "SMALL", you should set their crossover frequency correctly according to their frequency characteristics. (For details, refer to "When selecting the SPEAKER
•When "SUBWOOFER" is set to "NONE", "FRONT" is automatically set to "LARGE".
•When the "FRONT" is set to "SMALL", "CENTER", "SURROUND", "SURR BACK" cannot be set to "LARGE" and "SUBWOOFER" is automatically set to "YES".
•When the "SURROUND" is set to "SMALL", "SURR BACK" cannot be set to "LARGE".
•When the power amplifier for surround back/room 2 channels is assigned to "ROOM 2", the "SURR BACK" is automatically set to "NONE". (For details, refer to "When selecting the AMP ASSIGN" on page 37.)
When setting the speaker size by performing the auto setup.
If the speakers may not be detected properly because of incorrect connection, measurement environment, or other factors, the speakers are set as follows :
•When a pair of speakers such as front, surround or surround back speakers are detected differently (i.e, one is detected as "LARGE", the other as "SMALL"), both are automatically set to "SMALL".
•When only one surround speaker is detected, both are automatically set to "NONE".
•When only the surround back right speaker is detected, both are automatically set to "NONE".
In this case, connect that speaker to the SURROUND BACK/ROOM 2 LEFT speaker terminals and retry the auto setup, then it will be automatically set to "1CH".
4 | Repeat the above steps and until the speakers are all set to the desired mode. |
About the speaker size
•Select "LARGE" or "SMALL" not according to the actual size of the speaker but according to the speaker's capacity for playing low frequency (bass sound below frequency set on the SPEAKER
•If you do not know, try comparing the sound at both settings (setting the volume to a level low enough so as not to damage the speakers) to determine the proper setting.
•When setting the speaker size by performing the auto setup, depending on whether the measured crossover frequency of each speaker is lower or higher than 80 Hz, its size is automatically set to "LARGE" or "SMALL". (For details, refer to "When selecting the SPEAKER
46