GE JBP20, JBP19, JBPA48 warranty Volts minimum, 40 amperes, Copper Wiring

Page 31

PREPARE THE OPENING (cent’d)

Flooring Under the Range

Your range, like many other household items, is heavy and can settle into soft floor coverings such as cushioned vinyl or

carpeting. When moving the range on this type of flooring, use care, and follow these simple and inexpensive instructions.

The range should be installed on a 1/4 inch thick sheet of plywood (or similar material) as follows:

When the floor covering ends at the front of the

range, the area that the range will rest on should be built up with plywood to the same level or higher than the floor covering. This will allow the range to be moved for cleaning or servicing.

STEP 2

PREPARE FOR ELECTRICAL CONNECTION

Use only a 3-conductor, or if required a 4- conductor range cord set as noted below. These cord sets are provided with ring type terminals.

The electrical rating of the cord must be 125/250

volts minimum, 40 amperes.

NOTE: Only a 4-conductor cord is to be used when the appliance is installed in a mobile home or where local codes do not permit grounding through the neutral.

STEP 3

1.Locate connector block at the bottom rear of range and remove rear wiring cover.

2.Directly below the connector block is a hole with a knockout ring for accommodating conduit fittings. Brackets provided are used to support the flexible cord strain relief, which must be securely attached to the cord set.

TOR

STRAIN RELIEF (PROVIDED WIT

SET NOT PART

STEP 4

3-WIRE SYSTEM

Power Cord Installation-Insert screws through power cord terminals so that the screws pass through connector block terminals and engage nuts. Tighten screws securely.

i-

SCREW+

9POWER CORD

&/ RING TERMINAL

+::~:R

*

>?&

CONNECTOR

BLOCK& 4-;;!ABLE

TERMINAL

Cable Direct Installation-Clamp bare wires between the connector block terminals and movable nuts with screws tightened securely.

1.Copper Wiring

+ SCREW

- pl:fcToR

TERMINAL

Connect the neutral or grounded wire of the supply circuit to the neutral terminal of the connector block, located in the center. The power leads must be connected to the outside (brass colored) terminals.

NEUTRAL

TERMINAL

NG STRAP

ING TO RANGE)

WARNING: CONNECTOR BLOCK IS APPROVED FOR COPPER WIRE CONNECI’ION ONLY.

31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Useand Care & Installation Guide If you received Damaged range If YOU Need ServiceSave time and money. Before you request service Help US Help YOUAwarning Important Safety InstructionsSelf-Cieaning Oven Clean only parts listed in this Use and Care GuideSurface Cooking Units Save These InstructionsAlways turn the surface units off before removing cookware Features of Your Range JBP19JBP20 HOW does this Cooktop Compare To Your OLD ONE? How to Set the ControlsCooking Guide for Using Heat Settings Surface unit on indicator light will glowCanning should be done on surface units only Home Canning TipsCookware Wok CookingFlat-bottomed canners are recommended Features of Your Oven ControlOven Temperature Knob. Turn this knob Observe the Following Points in CanningTo Cancel the Timer To Set the Minute TimerTo Set the Timer To Reset the TimerUsing Your Oven Oven CONTROL, Clock and TimerAutomatic Oven Shut Off How to Set Your Range for BakingLight comes on automatically when the oven door is opened BakingBaking Guides Pan PlacementPreheating Baking PansAluminum Foil How to Time BakeHow to Set Immediate Start and Automatic Stop Tinied BakingQuick Reminder How to Set Delay Start and Automatic StopQuestions and Answers Tiimed BakingTo Adjust the Temperature on Models with Hour Pads Use of Aluminum Foil RoastingFrozen Roasts Whv is my roast crumbling when I try to care it?Should I salt the meat before broiling? Why are my meats not turning out as brown as they should?Broiling Leave the door open to Broil stop position. The doorSecond Side Oven door should be open to the broil stop positionBefore a Clean Cycle Operating the SELF-CLEANING OvenDampened cloth. The oven front frame To Stop a Clean Cycle How to Set the Oven for CleaningAfter a Clean Cycle IL?y How to Set Delay Start of Cleaning on some modelsWhy do I have ash left in my oven after cleaning? Should there be any odor during the cleaning?My oven shelves do not slide easily. What is the matter? Drip Pans Care and CleaningSurface Units and Drip Pans To remove a surface unitMetal Parts Lift-Up Cooktop on some modelsControl Panel and Knobs Oven VentLift-Off Oven Door Oven Light Replacement on some modelsPorcelain Enamel Cooktop Broiler Pan and Grid on some modelsOven Heating Elements Cooktop UP to 200F Installation InstructionsLarge blade screwdriver Hex head nutdriverVolts minimum, 40 amperes Copper WiringStep Wire System Special Grounding Instructions Problem Possible Cause Control knob riot set to Auto Self Clean To cool to room temperature and reset the controlsOther servicing generally should be referred to qualified We’ll Be ThereWarranty
Related manuals
Manual 44 pages 43.73 Kb

JBPA48, JBP20, JBP19 specifications

The GE JBP19, JBP20, and JBPA48 are notable models in the realm of gas ranges, all providing innovative features designed for enhanced cooking performance and efficiency. Their design focuses on user-friendly operation, reliable technology, and a range of modern conveniences catering to the needs of both amateur cooks and professional chefs.

The GE JBP19 is characterized by its sleek appearance and functional design. It offers a standard oven and a powerful cooktop with four burners, allowing for versatile cooking options. Equipped with a reliable electronic ignition system, the JBP19 ensures smooth and effortless starting of the burners. The oven features a traditional bake option and a broil function, making it ideal for a variety of cooking techniques, from baking to roasting. One standout feature is the self-cleaning option, which makes maintenance a breeze by reducing the need for manual scrubbing after heavy usage.

The GE JBP20 builds on the strengths of the JBP19 but introduces enhanced features for a more refined cooking experience. This model boasts a larger oven capacity, making it suitable for preparing larger meals or multiple dishes simultaneously. The cooktop features heavy-duty grates designed for durability and stability, providing a reliable surface for pots and pans of various sizes. The JBP20 is equipped with a precise temperature control system, ensuring uniform cooking results. In addition, it includes a storage drawer at the bottom, offering convenient space for cookware and utensils.

The GE JBPA48 represents the pinnacle of these models, incorporating advanced technology for the ultimate culinary experience. This model features dual ovens, allowing for simultaneous cooking at different temperatures. The stainless steel finish not only enhances its aesthetic appeal but also contributes to easy cleaning and maintenance. The JBPA48 also comes with smart technology, enabling connectivity with mobile devices. This allows users to monitor and control cooking settings remotely, providing unprecedented convenience and flexibility.

Overall, the GE JBP19, JBP20, and JBPA48 gas ranges stand out with their combination of functional design, advanced features, and user-friendly technology. Each model is tailored to meet diverse culinary needs while ensuring users can enjoy the cooking process without compromising on efficiency or results. Whether you're a novice home cook or an experienced chef, these gas ranges deliver exceptional performance and reliability for all your cooking endeavors.
Top Page Image Contents