GE 49-80591-2, JBP28DRCC Care and Cleaning Troubleshooting, Oven Light Replacement on some models

Page 29

GEAppliances.com

Safety

WARNING

CAUTION

ReceptacleSocket

ShOCK OR buRN hAZARD: before replacing oven light bulb, disconnect the electrical power to the range at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.

buRN hAZARD: The glass cover and bulb should be removed when cool. Touching hot glass with bare hands or a damp cloth can cause burns.

Oven Light Replacement (on some models)

Instructions

G6.35

Bulb

Tab

Glass cover

(on some models)

ReceptacleSocket

G9 Bulb

Tab

Glass cover (on some models)

To remove:

Turn the glass cover counterclockwise 1/4 turn until the tabs of the glass cover clear the grooves of the socket. Wearing latex gloves may offer

a better grip.

Using gloves or a dry cloth, remove the bulb by pulling it straight out.

To replace:

Use a new 120/130-volt halogen bulb, not to exceed 50 watts. Replace the bulb with the same type of bulb that was removed. Your model will have one of the two types shown on

the left. To determine the correct replacement bulb, check the bulb terminals. Bulbs with 2 straight pin terminals are G6.35 bulbs. Bulbs with 2 looped terminals are G9 bulbs. (Do not interchange.) Be sure the replacement bulb is rated 120 volts or 130 volts (NOT 12 volts).

Using gloves or a dry cloth, remove the bulb from its packaging. Do not touch the bulb with bare fingers. Oil from skin will damage the bulb and shorten its life.

Receptacle

Use gloves or cloth

Push the bulb straight into the receptacle all the way.

Place the tabs of the glass cover into the grooves of the socket. Turn the glass cover clockwise 1/4 turn.

For improved lighting inside the oven, clean the glass cover frequently using a wet cloth. This should be done when the oven is completely cool.

Reconnect electrical power to the oven.

Operating Instructions

Care and Cleaning Troubleshooting

Oven Light Replacement (models equipped with standard 40-watt appliance bulbs)

Wire cover holder

Be sure to let the light cover and bulb cool completely.

To remove the cover:

Hold a hand under the cover so it doesn’t fall when released. With fingers of the same hand, firmly push back the wire cover holder. Lift off the cover.

Do not remove any screws to remove the cover.

Replace bulb with a 40-watt appliance bulb.

To replace the cover:

Place it into groove of the light receptacle. Pull wire forward to the center of the cover until it snaps into place.

Connect electrical power to the range.

29

Tips Consumer Support

Image 29
Contents Printed on Recycled Paper Write the model and serial numbers here Model # Serial #ANTI-TIP Device Safety InstructionsGEAppliances.com SafetyTips Consumer Support Operating Instructions InstructionsSome models CleaningCleaning Consumer Support Troubleshooting Tips Care How to Set Using the surface units. on some modelsIndicator light will For glass cooktop surfacesInstructions Using the surface unitsSafety Home Canning Tips Care and Cleaning Troubleshooting Tips Consumer SupportFor Models With a Radiant Glass Cooktop Be sure the canner is centered over the surface unitConsumer Support Troubleshooting Care and CleaningOperating Instructions TipsSafety Instructions Using the oven control, clock Timer features and settingsCare and Cleaning Troubleshooting Tips Consumer SupportTouch this pad to select the broil function Troubleshooting TipsBefore you begin… Type of margarine will affect baking performance Using the ovenTroubleshooting Tips Consumer Support Broiling Guide How to Set the Oven for BroilingUsing the convection oven. on some models When Using the Warming Drawer Using the warming drawer. on some modelsTemperature Selection Chart To Crisp Stale ItemsCleaning Troubleshooting Tips Consumer Support Using the lower oven drawer. on some modelsWhen Using the Lower Oven Drawer Warm Setting CareSupport Using the clock and timerTroubleshooting Tips Care How to Set a Delayed Start and Automatic Stop Using the timed baking feature. on some modelsHow to Set an Immediate Start and Automatic Stop Tips Care Special features of your oven controlAdjust the oven thermostat-Do it yourself Cleaning Troubleshooting Tips Using the Sabbath feature. on some modelsHow to Exit the Sabbath Feature Designed for use on the Jewish Sabbath and holidaysHow to Set the Oven for Cleaning Using the self-cleaning oven. on some modelsBefore a Clean Cycle How to Delay the Start of Cleaning on some models CleaningTo Stop a Clean Cycle After a Clean CycleTo Begin Steam Clean Cycle Using Steam Clean. on some modelsDuring the steam clean Remove any remaining water with a dry cloth or spongeCare Care and cleaning of the rangeConsumer Support Troubleshooting Safety Operating InstructionsTips Care Removable Warming/Lower Oven Drawer Pan on some modelsLift-Off Oven Door Cleaning the Oven DoorStorage Drawer Removal Oven RacksOven Heating Elements To remove the drawerOven Light Replacement on some models Care and Cleaning TroubleshootingTips Care and Cleaning Cleaning the glass cooktop. on some modelsNormal Daily Use Cleaning Burned-On ResidueMetal Marks and Scratches Safety Instructions Operating InstructionsCooktop Seal Damage from Sugary Spills and Melted PlasticSurface Units Care and cleaning of the coil cooktop. on some modelsDrip Pans Lift-Up CooktopProblem Possible Causes What To Do Before you call for service…Mode Oven light does Light bulb is loose or defective Clock and timer do Plug on range is not completelyNot work Switch operating light For broiling Some areas the powerToo high to set a self-clean Oven will not self-clean Oven temperature isDuring a clean cycle Or letter flash Error codePower outage Power outage or surge Display flashes bAd Installed connectionTemperature setting too high Unable to get Oven control pads wereLimited Time Offer! Free Shipping AccessoriesGenuine GE Part Easy To Clean One-Year Warranty Page GE Will Provide GE Electric Range WarrantyWhat GE Will Not Cover For The PeriodParts and Accessories Schedule ServiceConsumer Support GE Appliances website Real life Design Studio