GE LGB146, LGB156, LGB116, LGB126, RGB526, RGB628, RGB535, RGB530, RGB532, RGB501, RGB525, JGBS15 General

Page 30

INSTALLATION INSTRUCTIONS

(continued)

GENERAL

See Dimensions and Clearances in this section for all rough-in and spacing dimensions. These dimensions must be met for safe use of your range. The location of the electrical outlet and pipe opening (see Gas Pipe and Electric Outlet Locations) may be adjusted to meet specific requirements.

The range may be placed with 0″ clearance (flush) at the back wall and side walls of the range.

LOCATION

Do not locate the range where it may be subject to strong drafts. Any openings in the floor or wall behind the range should be sealed. Make sure the openings around the base of the range that supply fresh air for combustion and ventilation are not obstructed by carpeting or woodwork.

PROTECT YOUR FLOOR

Your range, like many other household items, is heavy and can settle into soft floor coverings such as cushioned vinyl or carpeting. Use care when moving the range on this type of flooring. It is recommended that the following simple and inexpensive instructions be followed to protect your floor.

The range should be installed on a sheet of plywood (or similar material). When the floor covering ends at the front of the range, the area that the range will rest on should be built up with plywood to the same level or higher than the floor covering. This will allow the range to be moved for cleaning or servicing. Also, make sure your floor covering will withstand 180°F. (See the Important Safety Instructions section of the Installation Instructions.)

KITCHEN CABINETS

Make sure the wall coverings around your range can withstand the heat generated (up to 200°F) by the range. (See the Important Safety Instructions section of the Installation Instructions.)

MODEL AND SERIAL NUMBER LOCATION

Depending on your range, you’ll find the model and serial numbers on a label on the front frame of the range, behind the storage drawer, kick panel or broiler drawer.

TOOLS YOU WILL NEED

Phillips and flat-blade screwdrivers

Pencil and ruler

Two pipe wrenches (one for backup)

138open-end or adjustable wrench

Nut drivers or wrenches: 3/16″ and 1/4″

ADDITIONAL MATERIALS YOU MAY NEED

Gas line shut-off valve

Pipe joint sealant or UL-approved pipe thread tape with Teflon* that resists action of natural and LP gases

Flexible metal appliance connector (1/2″ I.D.) A 5-foot length is recommended for ease of installation but other lengths are acceptable. Never use an old connector when installing a new range.

Flare union adapter for connection to gas supply line (3/4″ or 1/2″ NPT x 1/2″ I.D.)

Flare union adapter for connection to pressure regulator on range (1/2″ NPT x 1/2″ I.D.)

*Teflon: Registered trademark of DuPont

PREPARATION

Remove all tape and packaging. Lift up the cooktop (on models with standard twin burners) and remove any packing material under it. Make sure the standard twin burners are properly seated and level.

Take the accessory pack out of the oven.

Check to be sure that no range parts have come loose during shipping.

30

Image 30
Contents Safety Instructions Operating Instructions, TipsIf YOU Need Service Help US Help YOU…Important Safety Instructions When You Get Your RangeUsing Your Range Surface Cooking Do not allow anyone to climb, stand orCleaning Your Range Save These INSTRUCTIONS5Baking, Broiling and Roasting Features of Your Range Features and appearance varyOven Control SeeSurface Burners, Grates and Drip Pans on some models Broiler Pan and GridBefore Lighting a Burner Surface CookingSurface Burner Controls To Light a Surface BurnerHow to Select Flame Size Top-of-Range CookwareDo not use a wok on any other support ring To Change or Cancel the Timer Setting Clock and TimerTo Set the Timer Display Clock While Timer Is OperatingUsing Your Oven Oven Shelves Shelf PositionsOven Vents To avoid possible burns, place the shelves How to Set Your Range for BakingBaking Type of Food Shelf PositionBaking Guides Pan PlacementPreheating CookiesBaking Pans PiesCakes Don’t PeekAdjust the Oven Thermostat To Adjust the ThermostatRoasting Roasting Guide Questions and AnswersWhy is my roast crumbling when I try to carve it? Frozen RoastsUse of Aluminum Foil Why are my meats not turning out as brown as they should?Broiling Should I salt the meat before broiling?Broiling Guide Ground BeefCare and Cleaning Standard Twin Burners on some modelsSealed Burner Assemblies on some models For proper ignitionBurner Grates Cooktop SurfaceOven Bottom Removable Broiler Drawer on some models Oven Light Bulb on some modelsControl Panel and Knobs Broiler Pan and GridOven Air Vents Removable Storage Drawer on some modelsRemovable Kick Panel on some models Lift-Off Oven Door Outside of doorOven bottom has a porcelain enamel finish Installation Instructions For Your SafetyImportant Safety Instructions General Provide Adequate GAS Supply Connect the Range to GAS Rigid Pipe Hookup for Models Equipped with Sealed BurnersElectrical Requirements Electrical Connections on some modelsGrounding Extension Cord CautionsElectrical Connections Electric DisconnectAdjust the Surface Burner Pilots if Necessary Light the Surface Burner PilotsLight the Oven Pilot Electric Ignition Models Light the PilotsQuality of Flames Yellow flamesTo remove the oven bottom Leveling the Range To remove the broiler drawer⁄ 8 ″ Page Page Page QUESTIONS? Before YOU Call for SERVICE… Problem Possible CauseDo It Yourself section We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration We’ll Be There Warranty