GE RGB530, LGB156 Light the Surface Burner Pilots, Adjust the Surface Burner Pilots if Necessary

Page 35

4 SEAL THE OPENINGS

Seal any openings in the wall behind the range and in the floor under the range when hookups are completed.

5 LIGHT THE PILOTS

(For Models Equipped with Standing Pilots. If the range is an electric ignition model, the burners are ignited by electric ignition which eliminates the need for standing pilot lights.)

The range should be installed in its permanent position before any pilots are lit or adjusted.

Light the Surface Burner Pilots

CAUTION: Make sure the surface burner control knobs are in the OFF position before attempting to light the pilots.

1.Raise the cooktop.

2.Light both pilots with a match.

3.To avoid pilot outage, use caution when closing cooktop after lighting pilots.

516

NOTE: Do not leave standing pilot lit in a newly constructed or remodeled home or apartment that will be unoccupied for more than a month.

Each pilot flame was adjusted at the factory to be approximately 5/16″ tall. A tinge of yellow appearing at the upper tip is normal. If you find pilot adjustment is necessary, follow instructions at right.

Adjust the Surface Burner Pilots if Necessary

1. Raise the cooktop.

2. Locate the pilot adjustment screw. It can be accessed through the small hole near the center of the manifold panel.

3.To adjust, use a blade-type screwdriver with a shaft diameter of less than 3/16″. Turn pilot adjustment screw until pilot is 5/16″ high. Do not reduce the flame to less than 5/16″ or pilot outage may occur. A pilot flame burning higher than recommended may generate soot (carbon black) on the bottom of your cooktop.

Light the Oven Pilot

CAUTION: Make sure the OVEN CONTROL knob is in the OFF position before attempting to light the pilot.

1.Remove the broiler drawer by sliding the drawer all the way out and then lifting slightly to remove it from its tracks.

2.Locate the pilot at the

back of the broiler compartment. The pilot is attached to the left side of the oven burner.

3.Light the pilot with a match. No adjustments are

required for natural gas. If range is connected to LP gas, contact the person who installed your range or

made the conversion.

(continued next page)

35

Image 35
Contents Operating Instructions, Tips Safety InstructionsHelp US Help YOU… If YOU Need ServiceUsing Your Range Important Safety InstructionsWhen You Get Your Range Do not allow anyone to climb, stand or Surface CookingBaking, Broiling and Roasting Cleaning Your RangeSave These INSTRUCTIONS5 Features and appearance vary Features of Your RangeBroiler Pan and Grid SeeSurface Burners, Grates and Drip Pans on some models Oven ControlTo Light a Surface Burner Surface CookingSurface Burner Controls Before Lighting a BurnerDo not use a wok on any other support ring How to Select Flame SizeTop-of-Range Cookware Display Clock While Timer Is Operating Clock and TimerTo Set the Timer To Change or Cancel the Timer SettingUsing Your Oven Oven Vents Oven ShelvesShelf Positions Type of Food Shelf Position How to Set Your Range for BakingBaking To avoid possible burns, place the shelvesCookies Pan PlacementPreheating Baking GuidesDon’t Peek PiesCakes Baking PansTo Adjust the Thermostat Adjust the Oven ThermostatRoasting Frozen Roasts Questions and AnswersWhy is my roast crumbling when I try to carve it? Roasting GuideShould I salt the meat before broiling? Why are my meats not turning out as brown as they should?Broiling Use of Aluminum FoilGround Beef Broiling GuideStandard Twin Burners on some models Care and CleaningFor proper ignition Sealed Burner Assemblies on some modelsOven Bottom Burner GratesCooktop Surface Broiler Pan and Grid Oven Light Bulb on some modelsControl Panel and Knobs Removable Broiler Drawer on some modelsRemovable Kick Panel on some models Oven Air VentsRemovable Storage Drawer on some models Outside of door Lift-Off Oven DoorOven bottom has a porcelain enamel finish For Your Safety Installation InstructionsImportant Safety Instructions General Provide Adequate GAS Supply Rigid Pipe Hookup for Models Equipped with Sealed Burners Connect the Range to GASExtension Cord Cautions Electrical Connections on some modelsGrounding Electrical RequirementsElectric Disconnect Electrical ConnectionsLight the Oven Pilot Adjust the Surface Burner Pilots if NecessaryLight the Surface Burner Pilots Yellow flames Light the PilotsQuality of Flames Electric Ignition ModelsTo remove the oven bottom To remove the broiler drawer Leveling the Range⁄ 8 ″ Page Page Page Problem Possible Cause QUESTIONS? Before YOU Call for SERVICE…Do It Yourself section We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration We’ll Be There Warranty