GE JGSP22 A number or, Display flashes, Unable to get, Display to show SF, Power outage, Vent

Page 30

Customer Service Troubleshooting Tips Care and Cleaning Operating Instructions Safety Instructions

Before You Call For Service (cont.)…

Troubleshooting Tips

Problem		Possible Causes		What To Do

“F— and a number or		You have a function error code.		• Press the CLEAR/OFF pad. Allow the oven to cool for
letter” flash in the display				one hour. Put the oven back into operation.

		If the function code repeats.		• Disconnect all power to the range for at least 30
				seconds and then reconnect power. If the function
				error code repeats, call for service.

Display flashes		Power failure.		• Reset the clock.

Unable to get the		Oven control pads were		• The BAKE and BROIL HI/LO pads must be pressed
display to show “SF”		not pressed properly.		at the same time and held for 3 seconds.

Power outage,		Power outage or surge.		• Reset the clock. If the oven was in use, you must reset
clock flashes				it by pressing the CLEAR/OFF pad, setting the clock
				and resetting any cooking function.

“Burning” or “oily”		This is normal in a new oven		• To speed the process, set a self-clean cycle for a
odor emitting from		and will disappear in time.		minimum of 3 hours. See the Using the self-
the vent				cleaning oven section.

Strong odor		An odor from the insulation		• This is temporary.
		around the inside of the oven
		is normal for the first few times
		the oven is used.

		Improper air/gas ratio in		• Call for service.
		the oven.

Fan noise		A cooling fan may		• This is normal. The cooling fan will turn off and on.
		automatically turn on and
		off to cool internal parts.

30

Image 30

Contents RangesGas Slide-In ANTI-TIP Device Removing Packing MaterialsService Partnership Staple sales slip or cancelled check hereWrite the model and serial numbers here Customer Service Important Safety NoticeSafety Precautions All ranges can tip and injury could resultSafety Instructions Surface Burners Cook Meat and Poultry THOROUGHLY… SELF-CLEANING OvenTips Customer Service OvenFlooring Under the Range Service TroubleshootingConversion Leveling the RangeUsing the surface burners SafetyUsing the oven controls Cleaning Operating Instructions Safety InstructionsCustomer Service Troubleshooting Tips Care Care and Cleaning Troubleshooting Special features of your oven controlFahrenheit or Centigrade Temperature Selection Hour Shut-OffHour, 24 Hour or Clock Black-Out InstructionsTones at the End of a Timed Cycle Your control is set to use a 12 hour clockSafety Instructions Operating Cook and HoldChanging the Speed of the Increase or Decrease Pads Using the oven Cleaning OperatingTips Care Care and Cleaning ServiceHow to Set the Oven for Broiling Broiling GuideHI Broil Using the clock and timer CleaningCustomer Service Troubleshooting Tips Using the timed baking and roasting featuresSafety Instructions How to Set an Immediate Start and Automatic StopAdjust the oven thermostat-Do it yourself To Adjust the ThermostatType of margarine will affect baking performance Using the self-cleaning oven Before a Clean CycleHow to Set the Oven for Cleaning After a Clean Cycle How to Delay the Start of CleaningBurner Assembly Care and cleaning of the rangeHow to Remove Packaging Tape Control KnobsCleaning Troubleshooting Burner GratesOven Shelves Removable Storage Drawer Tips Care and Cleaning Operating Instructions SafetyLift-Off Oven Door Painted SurfacesOven Light Bulb Troubleshooting Tips Customer ServiceBroiler Pan & Grid Removable Oven BottomOperating Instructions Safety Anti-Tip DeviceControl Panel Before You Call For Service… Problem Possible Causes What To DoBefore You Call For Service cont.… Is on when you want After a clean cycle Oven not clean after aClean cycle Food does not bakeDisplay flashes Power outageA number or Unable to getGas Range Warranty Cleaning Troubleshooting Tips Customer ServiceService Telephone Numbers Special Needs Service In the U.S