GE JGBP35, JGBP79, JGBP90, JGBP85 Installing the Anti-Tip Device, When All Hookups Are Completed

Page 43

Installing the Anti-Tip Device

WARNING:

■Range must be secured with an approved Anti-Tip device.

■Unless properly installed, the range could be tipped by you or a child standing, sitting or leaning on an open door.

■After installing the Anti-Tip device, verify that it is in place by carefully attempting to tilt the range forward.

■This range has been designed to meet all recognized industry tip standards for all normal conditions.

■The use of this device does not preclude tipping of the range when not properly installed.

■If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB02X7909.

Mark the wall where the RIGHT EDGE of the range is to be located. Be sure to allow for the countertop overhang if you intend to install the range next to cabinets.

Anti-Tip device

Slotted head screw

Wallplate

Approx. 20°

2

⁄ ”

Marked edge of range

 

1 8

Using the device as a template, mark the position of the hole for the screw.

For wood construction, drill a pilot hole at an angle of 20 degrees from the horizontal. A nail or awl may be used if a drill is not available.

Mount the Anti-Tip device with the screw provided.

For cement or concrete construction, you will need a 1/4″ x 11⁄2″ lag bolt and a 1/2″ O.D. sleeve anchor, which are not provided. Drill the recommended size hole for the hardware.

Wallboard

Back of range

Anti-Tip device

Wood screw

Install the sleeve anchor into the drilled hole and then install the lag bolt through the device. The bolts must be properly tightened as recommended for the hardware.

Slide the range against the wall, and check for proper installation by grasping the front edge of the cooktop and carefully attempting to tilt the range forward.

Safety Instructions Operating Instructions Installation Instructions

Locate the outside edge of the device 21⁄8″ toward the center of the range from the marked edge of the range.

When All Hookups Are Completed:

MAKE SURE ALL CONTROLS ARE LEFT IN THE OFF

MAKE SURE THE FLOW OF COMBUSTION AND

POSITION.

VENTILATION AIR TO THE RANGE IS UNOBSTRUCTED.

Converting to LP Gas (or converting back to natural gas from LP)

Troubleshooting Tips Customer

This range leaves the factory set for use with natural gas. If you want to convert to LP gas, the conversion must be performed by a qualified LP gas installer.

The conversion instructions, sticker and LP orifices can be found attached to the range next to the pressure regulator.

There is a second set of instructions included in the envelope containing the product wiring diagrams on the back of the range. Keep these instructions and the orifices in case you want to convert back to natural gas.

43

Service

Page 42 Page 44
Image 43
Page 42 Page 44
Contents Cleaning Gas ANTI-TIP Device Customer ServiceTwo easy ways to register your appliance GE & You, a Service PartnershipImportant Safety Notice Safety Instructions Surface Burners Cook Meat and Poultry THOROUGHLY… Instructions Installation InstructionsElectric Warming Drawer on some models Instructions Using the surface burnersSafety Instructions OperatingTop-of-Range Cookware Operating Instructions SafetySafety Instructions Operating Using the oven controlsFunctions must be reset Instructions Safety InstructionsControl Lockout Special features of your oven control on some modelsFahrenheit or Centigrade Temperature Selection Hour Shut-OffHour, 24 Hour or Clock Black-Out Tones at the End of a Timed CycleCook and Hold Safety Instructions OperatingOven Vent Using the ovenPower Outage for Electric Ignition Models Before you begin…Oven Moisture How to Set the Oven for Baking or RoastingPreheating and Pan Placement Aluminum FoilBroiling Guide How to Set the Oven for BroilingHI Broil Power Outage Using the clock and timerInstallation Instructions To Set the TimerHow to Set a Delayed Start and Automatic Stop Using the timed baking and roasting featuresSafety Instructions How to Set an Immediate Start and Automatic StopAdjust the oven thermostat-Do it yourself Rack Using the electric warming drawerWhen Using the Warming Drawer Control KnobTo Crisp Stale Items Temperature Selection ChartTroubleshooting Tips Using the self-cleaning ovenTips Customer Service Care and cleaning of the rangeStandard Twin Burner Assemblies on some models Sealed Burner Assemblies on some models Instructions Operating Instructions SafetyCooktop Surface Burner GratesOven Bottom Lift-Off Oven Door To clean the outside of the doorBroiler Pan and Grid Removable Warming Drawer on some models Oven Light Replacement on some modelsRemovable Storage Drawer on some models To raise the cooktop Troubleshooting Tips Customer ServiceOven Air Vents Control Panel and KnobsFluorescent Top Light on some models Oven ShelvesBrushed Chrome Cooktop on some models Warming Drawer RackOperating Instructions Installation of the rangeSafety Instructions 361⁄4 ± 1⁄4 ServiceCustomer 28 ⁄ toLocation Provide Adequate Gas Supply Operating InstructionsConnect the Range to Gas Troubleshooting Tips Gas Flow into Range Installer InformRigid Pipe Hookup for Models Equipped with Sealed Burners Temporary Method Extension Cord CautionsGrounding IMPORTANT-Please read carefully Preferred MethodElectric Ignition Models Electric DisconnectSeal the Openings Check Ignition of Surface BurnersCheck Ignition of Oven Burner Quality of FlamesYellow tips on outer cones- Normal for LP gas To remove the oven bottom Leveling the RangeWhen All Hookups Are Completed Installing the Anti-Tip DeviceTroubleshooting Tips Customer Instructions Operating Instructions Safety Instructions Before You Call For Service…Entering cooking time Control signals afterOven temperature too Clock and timerCrackling or After a clean cycle Oven not clean after aClean cycle Is on when you wantDisplay flashes Power outageDoor appears Display goes blankOperating Instructions Operating Instructions Installation Instructions Customer Service We’ll Cover Any Appliance. Anywhere. Anytime Consumer Product Ownership Registration Safety Instructions One Year GE Will ReplaceWhat GE Will Not Cover For The PeriodWhat Is Not Covered GE Gas Range Warranty For customers in CanadaGE Answer Center Service Telephone Numbers
Top Page Image Contents