GE JGBP85 Door appears, Display goes blank, Display flashes, Unable to get, Display to show SF

Problem	Possible Causes		What To Do
“Door” appears in the		Self-cleaning cycle has been	•Move the latch handle all the way to the right.
display (on models with		selected but the latch handle
a door latch)		was not moved all the way
		to the right.
		Latch handle was moved to	•Move the latch handle to the right only when setting
		the right but a program other	the self-cleaning cycle.
		than self-cleaning was selected.
Display goes blank	A fuse in your home may be		• Replace the fuse or reset the circuit breaker.
	blown or the circuit
	breaker tripped.
	The clock is in the		• See the Special features of your oven control section.
	black-out mode.
Display flashes	Power failure.		• Reset the clock.
Unable to get the	Oven control pads were		• The BAKE and BROIL HI/LO pads must be pressed at
display to show “SF”	not pressed properly.		the same time and held for 3 seconds.
Power outage,	Power outage or surge.		• Reset the clock. If the oven was in use, you must reset
clock flashes			it by pressing the CLEAR/OFF pad, setting the clock
			and resetting any cooking function.
“Burning” or “oily”	This is normal in a new oven		• To speed the process, set a self-clean cycle for a
odor emitting from	and will disappear in time.		minimum of 3 hours. See the Using the self-
the vent			cleaning oven section.
Strong odor	An odor from the insulation		• This is temporary.
	around the inside of the oven
	is normal for the first few times
	the oven is used.
Fan noise	A cooling fan may		• This is normal. The cooling fan will turn off and on.
	automatically turn on and
	off to cool internal parts.
Drawer does not slide	The drawer is out of alignment.		• Fully extend the drawer and push it all the way in.
smoothly or drags			See the Care and cleaning of the range section.
	Drawer is over-loaded or load		• Reduce weight. Redistribute drawer contents.
	is unbalanced.
Warming drawer will	A fuse in your home may be		• Replace the fuse or reset the circuit breaker.
not work	blown or the circuit breaker
	tripped.
	The oven is self-cleaning.		• Wait for the self-clean cycle to finish and the oven
			to cool.
	Controls improperly set.		• See the Electric warming drawer section.
Excessive condensation	Liquid in warming drawer.		• Remove liquid.
in the warming drawer
	Uncovered foods.		• Cover food with lid or aluminum foil.
	Temperature setting too high.		• Reduce temperature setting.
Food dries out in the	Moisture escaping.		• Cover food with lid or aluminum foil.
warming drawer
			47

Safety Instructions Operating Instructions Installation Instructions Troubleshooting Tips Customer Service