GE JGBP29GES How to Set Oven for Cleaning, How to Set a Delayed-Start Cleaning, Start and Stop

How to Set Oven for Cleaning

Step 1: Turn the OVEN	OVEN S~	OVEN~MP
SET knob to CLEAN.	c-	+
Push in and turn the
OVEN TEMP knob to ~	,L~	;
CLEAN. Controls will

snap into final position @ when the CLEAN

location is reached.

Step 2: Slide the latch — handle to the right as far

as it will go.

Never force the door latch handle. Forcing the handle may damage the door lock mechanism.

Step 3: Set the automatic oven timer.

Make sure the range

:::::;;; @o@@ correct time of day.

START and STOP 6’

TIME dials of any

previous timed cooking or cleaning function by: one at a time, push the DELAY START and STOP TIME knobs in and turn the knob. Using a light touch, continue turning the knob until it “pops” out. Both knobs should now be in the out position.

●Decide on cleaning hours necessary. Recommended Cleaning Time:

Light to Moderate Soil—2-3 hours (thin spills and light spatters)

Heavy Soil- hours (heavy, greasy spills and spatters)

●Add these hours to present time of day, then push in and turn the STOP TIME dial clockwise to this later stop time.

Oven door gets hot during self-cleaning. DO NOT TOUCH.

The CLEANING light will glow, indicating the controls have been set correctly and the clean cycle has begun. If a delayed start has been selected, the CLEANING light will not glow until the start time has been reached and the clean cycle begins. The door will lock approximately 20 minutes after the clean cycle has begun.

How to Set a Delayed-Start Cleaning

If you wish to start and stop	OVEN TEMP
cleaning at a later time than shown
on the clock, push in and turn the
DELAY START dial to time you
wish to start. Add the hours needed
for cleaning to this “start” time, then
push in and turn the STOP TIME
dial to this later stop time. The oven
will automatically turn on and off at
the set times.

After a Clean Cycle

After cleaning is comulete, the door will stav locked

o~n~~~r. ~$f kyc

Never force the latch handle. The latch slides easily. Forcing the latch handle may damage the door lock.

Step 2: Turn the OVEN TEMP knob to OFF.

After a clean cycle, you may notice some white ash in the oven. Just wipe it up with a damp cloth.

If white spots remain, remove them with a soap-filled steel wool pad. Be sure to rinse thoroughly with a vinegar and water mixture. These deposits are usually a salt residue that can not be removed by the clean cycle. If the oven is not clean after one cycle, the cycle may be repeated.

(continued next page)

21