Maytag RJGR, DGRSC manual Component Testing Procedures

Page 14

Component Testing Procedures

!WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power and shut off gas to unit before servicing, unless testing requires power.

Illustration	Component	Test Procedure	Results
	270° valve	Verify gas is supplied.
		Orifice adjusted for
		Natural or LP.
		Adjust set screw for simmer control.	See conversion section.
	Spark 270° switch	Unplug switch harness at rear of	120 VAC
		range. Test for continuity at wire
		terminals.
		Switch in LITE position	Continuity
		Switch in any other position	Infinite
	Top surface burner	Verify gas is supplied	Check for obstructions in burner ports.

Verify burner cap is positioned correctly.

16023219

Image 14

Contents Service Important Information Customer Service Support CenterRecognize Safety Symbols, Words, and Labels Web Site Telephone NumberTable of Contents Oven Fires Safety InformationRecognize this symbol as a safety precaution Receiving Oven Safety Practices for ServicerServicing Case of Fire Delayed IgnitionUsing the Oven Bake Burner FlameExtension Cord Connecting Range to GasElectrical Requirements GroundingPressure Regulator Product Safety DevicesOven Safety Valve Gas Burner OrificesGeneral Information Ordering Replacement PartsGeneral Information Model Identification ServiceParts and Accessories Gas ValveTroubleshooting Procedures Problem Possible Cause Correction Component Testing Procedures Component Testing Procedures Control Panel, Rocker Switches, and Indicator Lights Disassembly ProceduresRemoving and Replacing Unit Surface Burner Micro Switches Oven and Surface Broiler Infinite SwitchOven Light Socket Spark ModuleModules Removal Convection FanBackgaurd Broil Burner and IgnitorBake Gas Valves Top Side PanelGas Regulator Door DisassemblyDoor Removal Manifold PipeSurface Burner Front FacadeModule Type CharboilThis page is intentionally left Blank