Disassembly Procedures
!WARNING
To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and shut off gas supply before following any disassembly procedure.
Door Removal
1.Remove bottom kick plate.
•Pull outward on bottom portion of the kick plate to release.
•Push upward on kick plate to release and remove from unit.
2.Release tension spring on door hinge, by completely removing nut from eyebolt.
3.Remove eyebolt from hinge hanger.
4.Remove hinge hanger from door hinge.
NOTE: Once hinge bolts are removed, oven door will fall. Secure oven door before removing hinge bolts.
5.Remove bolts securing door hinge to chassis.
•Located behind oven door hinges is a metal spacer.
6.Remove door from unit.
Door Disassembly
1.Remove oven door, see "Door Removal" procedure.
2.Place door on a protected surface to prevent damaging the oven door.
3.Remove screws securing the bottom and sides of the door.
NOTE: Located on the side screws is a nut used a spacer between outer shell and inner door assembly.
4.Carefully pry the bottom corners outward on outer shell to allow outer shell to bypass door hinges.
5.Remove screws securing door handle and replace if necessary.
6.Remove screws securing outer door glass and replace if necessary.
7.Remove screws securing inner door glass brackets and replace glass if necessary.
8.remove nuts securing inner door wrapper to inner door.
9.Remove insulation to gain access to inner window assembly.
10.Remove nuts securing inner window assembly and replace if necessary.
11.Replace component and reverse procedures to reassemble.
Gas Regulator
1.Turn off gas and power supply to the oven.
2.Remove surface module, located on the right side of unit. See module type for removal procedures.
NOTE: Complete disassembly of module may not be required to gain access to gas regulator.
3.Disconnect all gas lines from gas regulator.
4.Replace component and reverse procedure to reassemble.
NOTE: When installing, use pipe dope compound. Perform gas leak test to ensure unit will not leak and unit operates properly.
Manifold Pipe
1.Turn off gas and power supply to the oven.
2.Release control panel cover, see "Control Panel" procedure, steps 1 through 5.
3.Remove micro switches from all surface valves.
4.Cut plastic ties securing wiring to manifold pipe.
5.Disconnect gas lines, at the union from manifold pipe.
6.Remove bolts securing gas manifold to burner box.
7.Remove surface valves from manifold pipe.
8.Replace component and reverse procedure to reassemble.
NOTE: When installing valve, use pipe dope compound. Perform gas leak test to ensure unit will not leak and unit operates properly.
18 | 16023219 | ©2004 Maytag Services |