Disassembly Procedures
!WARNING
To avoid the risk of electrical shock, personal injury or death; disconnect power to oven and shut off gas supply before following any disassembly procedure.
Spark Module
1.Turn off gas and power supply to the oven.
2.Release control panel cover, see "Control Panel" procedure, steps 1 through 5.
3.Locate spark module, looking through control panel inside the burner box area at the rear of the unit.
4.Remove surface module located on top of spark module, to gain access to spark module.
NOTE: Disconnect gas line at the surface valve for module removal.
5.Remove screws securing spark module mounting bracket to back of unit. Allow mounting bracket to fall into burner box area.
6.Disconnect and label wire terminals from spark module.
7.Release plastic tabs securing spark module to mounting bracket.
8.Replace component and reverse procedures to reassemble.
NOTE: Perform gas leak test to ensure unit will not leak and unit operates properly.
Module(s) Removal
1.Remove top assembly pieces from module.
2.Disconnect and label wire terminals from module.
3.Disconnect gas line from the surface valve.
4.Raise upward on the rear of the module and side back slightly to release module from orifice and place to the side.
5.Reverse procedure to reassemble.
Oven Light Socket
1.Turn off gas and power supply to the oven.
2.Identify location of failed oven light.
•If located on an outside oven wall, remove appropriate side panel, to gain access to oven light, see "Side Panel" procedure.
•If located on oven interior wall,
3.Disconnect and label wire terminals from light socket.
4.Open oven door and remove light lens cover from light socket.
5.Release metal tabs on light socket and allow light socket to release into the oven cavity area.
6.Replace component and reverse prodceure to assemble.
Convection Fan
1.Open oven door and remove oven racks from the oven cavity.
2.Remove screws securing convection fan cover to the rear of the oven cavity.
3.Raise upward on convection fan cover to release from supporting bracket.
4.Remove bolts securing convection fan to mounting bracket.
5.Pull convection fan into oven cavity area and place to the side.
6.Reach through convection fan hole located in the rear of the oven cavity, following the wires.
7.Locate the terminal wire plug, sqeeze the side of the terminal plug and pull to release.
8.Remove convection fan from the oven cavity.
9.Loosen set screw securing the fan blade to the convection fan shaft and remove fan blade.
10.Remove nuts securing convection fan to the mounting bracket.
11.Replace component and reverse procedures to reassemble.
NOTE: When securing fan blade to the new convection fan shaft allow approximately 1/4" from the mounting bracket. Spin fan blade to ensure blade spins freely.
Bake Burner and Ignitor
1.Shut off power and gas supply to unit.
2.Remove kick plate from under oven needing servicing.
3.Disconnect and label wire terminals from gas valve.
4.Remove items and oven racks from oven cavity.
5.Grasp front corners of oven bottom, lift and pull forward to remove from oven cavity.
6.Remove screw securing bake burner to oven chassis, located at the rear of oven cavity.
7.Grasp burner and slide to the rear, while maneuvering burner to either side to release from burner orifice.
8.Remove screws and nuts securing ignitor to bake burner.
9.Replace component and reverse procedure to reassemble.
16 | 16023219 | ©2004 Maytag Services |