Amana Coil important safety instructions Troubleshooting, Problem Solution

Page 22

Troubleshooting

PROBLEM

SOLUTION

For most concerns, try these first.

• Check if oven controls have been properly set.

 

• Check to be sure plug is securely inserted into receptacle.

 

• Check or re-set circuit breaker. Check or replace fuse.

 

• Check power supply.

 

 

Part or all of appliance does not

• Check if surface and/or oven controls have been properly set. See pages 4-14.

work.

• Check if oven door is unlocked after self-clean cycle. See page 16.

 

• Check if oven is set for a delayed cook or clean program. See pages 10 & 15.

 

• Check if Control Lock is activated. See page 9.

 

• Check if control is in Sabbath Mode. See page 12.

 

 

Clock, indicator words, and/or

• Oven may be set for a Cook & Hold or delay function.

lights operate but oven does

• The Control Lock may have been set. See page 9.

not heat.

 

 

 

Baking results are not as

• Make sure the oven vent has not been blocked. See page 14 for location.

expected or differ from

• Check to make sure range is level.

previous oven.

• Temperatures often vary between a new oven and an old one. As ovens age, the oven

 

temperature often “drifts” and may become hotter or cooler. See page 12 for

 

instructions on adjusting the oven temperature (select models). NOTE: It is not

 

recommended to adjust the temperature if only one or two recipes are in question.

 

 

Food is not broiling properly or

• Check oven rack positions. Food may be too close to element.

smokes excessively.

• Broil element was not preheated.

 

• Aluminum foil was incorrectly used. Never line the broiler insert with foil.

 

• Oven door was closed during broiling. Leave the door open to the first stop position

 

(about 4 inches).

 

• Trim excess fat from meat before broiling.

 

• A soiled broiler pan was used.

 

• Voltage in house may be low.

 

 

Oven will not self-clean

• Check to make sure the cycle is not set for a delayed start. See page 15.

(select models).

• Check if door is closed.

 

• Check if control is in Sabbath Mode. See page 12.

 

• Oven may be over 400° F. Oven temperature must be below 400° F to program a

 

clean cycle.

 

 

Oven did not clean properly

• Longer cleaning time may be needed.

(select models).

• Excessive spillovers, especially sugary and/or acidic foods, were not removed prior

 

to the self-clean cycle.

 

 

Oven door will not unlock after

• Oven interior is still hot. Allow about one hour for the oven to cool after the

self-clean cycle (select models).

completion of a self-clean cycle. The door can be opened when the LOCK is not

 

displayed.

 

• The control and door may be locked. See page 9.

 

 

 

cont.

21

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Electric Range Coil To Prevent Fire or Smoke Damage Recognize Safety Symbols, Words, LabelsInstructions Case of FireCooking Safety Important Safety InstructionsChild Safety Utensil SafetyCleaning Safety Self-Clean Oven select modelsImportant Safety Notice and Warning CooktopSetting the Controls Suggested Heat SettingsSurface Controls Drip Bowls Coil Element SurfaceCoil Elements To protect drip bowl finishSetting the Timer Manual Clean Oven ControlUsing the Touchpads Setting the ClockSetting the Controls For Broiling Setting the Controls For Baking or RoastingBaking, Roasting and Broiling G H I J Self-Clean Oven ControlClock To change the clock to 24-hour formatLocking the Controls TimerFault Codes BakingBaking Notes Delay BakeCook & Hold Baking Differences Between Your Old and New OvenKeep Warm Keep Warm NotesAdjusting the Oven Temperature Automatic Shut-Off/Sabbath ModeSabbath Mode Notes Broil Notes Broiling ChartBroiling Rack Total Foods PositionOven Bottom Oven VentOven Light Rack PositionsTo set Self-Clean Before Self-CleaningTo Delay a Self-Clean Cycle During the Self-Clean Cycle After Self-CleaningCleaning Procedures Care & CleaningPart Procedure 20000008 Is not wiped up, it may discolor the porcelainSelect models Follow with Stainless Steel Magic SprayOven Window MaintenanceOven Door To protect the oven door windowConvenience Outlet Leveling LegsStorage Drawer Canadian models onlyTroubleshooting Problem SolutionNoises may be heard ServicerOff. This is normal What is Not Covered By These Warranties Warranty & ServiceWarranty If You Need ServiceCuisinière électrique en éléments spiralés Avertissement Pour réduire le Pour éviter un incendie ou des dommages de fuméeToute Cuisinière Peut Basculer ET Provoquer DES Blessures Les instructions de sécurité importantes et les paragraphesFamiliarisation avec l’appareil En cas d’incendieSécurité pour les enfants Cuisson et sécuritéÉléments spiralés Ustensiles et sécuritéTable de cuisson FriteusesAvertissement et avis important pour la sécurité Nettoyage et sécuritéFour autonettoyant Conserver ces instructions pour consultation ultérieureCuisson sur la surface Boutons de commandeRéglage des commandes Suggestions pour le réglageÉléments spiralés Éléments de la table de cuissonRemarques Cuvettes de récupérationUtilisation des touches Commandes du four à nettoyage manuel certains modèlesCuisson dans le four Programmation de la minuterieCuisson courante, rôtissage et cuisson au gril Programmation des commandes pour la cuisson au grilChoisir le réglage Hi pour un gril normal BC D G H I J Commandes du four à autonettoyage certains modèlesHorloge Changement de l’horloge à un format de 24 heuresMinuterie Verrouillage des commandesCodes d’anomalie Différences de cuisson entre l’ancien four et le nouveau Cuisson couranteCuisson et maintien Remarques sur la cuisson courante au fourCuisson courante différée Programmation du maintien au chaud Maintien au chaudRemarques sur la fonction maintien au chaud Annulation du maintien au chaudArrêt automatique/Mode sabbat Remarques sur le mode sabbatAnnulation du mode sabbat Ajustement de la température du fourTableau de cuisson au gril Cuisson au grilRemarques sur la cuisson au gril Position Degré DE Temps DE Cuisson AlimentsSole du four Évent du fourÉclairage du four Positions des grillesProgrammation de l’autonettoyage NettoyageAvant l’autonettoyage Démarrage différé d’un cycle d’autonettoyagePendant le cycle d’autonettoyage Après le cycle d’autonettoyageMéthodes de nettoyage Grilles du four Nettoyer avec de l’eau savonneuse Certains modèles En le vaporisant d’abord sur un lingeRisqueraient de rayer le verre SécherHublot du four EntretienPorte du four Lampe du fourPrise de courant auxiliaire Pieds de réglage de l’aplombTiroir de remisage DéposeProblème Solution Recherche des pannesCodes d’anomalie Fumée lors de la mise en marcheOpération d’autonettoyage ’appareil et prendre contact avec un réparateur autoriséNe sont pas couverts par ces garanties Garantie et service après-venteGarantie Si vous avez besoin d’aideEstufa Eléctrica con Elementos Tubulares Fecha de Compra Para Evitar un Incendio o Daño Causado por el HumoEn EE. UU En Canadá Instrucciones Generales En Caso de IncendioSeguridad para los Niños Seguridad al CocinarElementos Tubulares CubiertaSeguridad sobre el Uso de Utensilios Ollas FreidorasAviso y Advertencia Importante Sobre Seguridad Seguridad en la LimpiezaHorno Autolimpiante Conserve estas instrucciones para referencia futuraProgramación de los Controles Cocinando en la EstufaControles Superiores Ajustes de Calor SugeridosElementos Tubulares Superficie de los Elementos TubularesNotas Platillos ProtectoresUso de las Teclas Cocinando en el HornoControles del Horno de Limpieza Manual Programación del TemporizadorAjuste de los Controles para Asar a la Parrilla Horneado, Asado y Asado a la ParrillaMayores tiempos de cocción tales como la carne de ave Para cambiar el reloj a formato de 24 horas Controles del Horno Autolimpiante modelos selectos‘Clock’ Reloj Programación del Reloj‘Timer’ Temporizador Códigos de ErroresBloqueo de los Controles Notas sobre Horneado ‘Cook & Hold’ Cocción y‘Bake’ Horneado Mantener Caliente‘Delay Bake’ Horneado Diferido ‘Keep Warm’ Mantener Caliente Para cancelar ‘Keep Warm’Oprima la tecla ‘CANCEL’ Retire el alimento del horno Notas sobre ‘Keep Warm’Ajuste de la Temperatura del Horno Cierre Automático/Modo SabáticoNotas Sobre el Modo Sabático Tabla de Asar a la Parrilla ‘Broiling’ Asar a la ParrillaNotas Sobre Asado a la Parrilla Termino DE Tiempo Total DE AlimentosParrillas del Horno Respiradero del HornoPanel Inferior del Horno Posiciones de la ParrillaPara diferir un ciclo de autolimpieza Para programar ‘Self-Clean’ AutolimpiezaAntes de la Autolimpieza Nota Para la limpieza manual, ver páginaDurante el Ciclo de Autolimpieza Después del Ciclo de AutolimpiezaProcedimientos de Limpieza Pieza Procedimiento DE LimpiezaCuidado y Limpieza Ventana del Horno MantenimientoPuerta del Horno Luz del HornoGaveta de Almacenamiento Tornillos NiveladoresTomacorriente para Electrodomésticos Pequeños Modelos Canadienses solamenteProblema Solución Localización y Solución de AveríasSe escuchan ruidos Códigos de ErroresModelos selectos Se apagan. Esto es normalLo que no cubren estas garantías Garantía y ServicioGarantía Si necesita servicio

Coil specifications

Amana Coil is a leading manufacturer of high-quality heating and cooling products, recognized for its innovative technologies and commitment to energy efficiency. One of the key features that distinguishes Amana Coil from its competitors is its advanced coil design, which significantly enhances the performance of the HVAC systems. The coils are constructed using high-grade copper and aluminum materials that not only provide superior thermal conductivity but also ensure longer service life.

One of the notable technologies employed in Amana Coil products is the use of advanced refrigerant technology. The use of eco-friendly refrigerants, such as R-410A, helps reduce the environmental impact while maintaining excellent cooling efficiency. This is especially crucial in today's market, where environmental sustainability is becoming a top priority for both consumers and manufacturers.

Amana Coil products also incorporate multi-stage cooling and heating systems. This technology allows for better temperature control and more consistent comfort levels within the home. By adjusting the output based on current heating or cooling demands, these systems are able to operate more efficiently, leading to lower energy bills. Additionally, the variable-speed fan motors found in many Amana Coil models provide enhanced airflow and reduced noise levels, contributing to a more pleasant indoor environment.

Durability is another critical characteristic of Amana Coil products. The precision-engineered coils are designed to withstand a variety of harsh operating conditions, ensuring longevity and reliability. The units are subject to rigorous testing, which guarantees that they can handle extreme temperatures and moisture levels without compromising performance.

Moreover, Amana Coil offers excellent warranty coverage, often providing a limited lifetime warranty on the compressor and a 10-year parts limited warranty. This reinforces the brand's confidence in its products and offers peace of mind to customers.

In summary, Amana Coil stands out in the HVAC market due to its attention to high-quality materials, energy-efficient technologies, and robust design. By focusing on innovative solutions and sustainable practices, Amana Coil continues to lead the way in providing superior heating and cooling systems that meet the needs of both residential and commercial customers. Buyers looking for reliable, efficient, and eco-friendly HVAC solutions will find Amana Coil a top choice in today's competitive market.
Top Page Image Contents