Bertazzoni Oven Troubleshooting: Fix Electric Oven Not Heating and More

	TROUBLESHOOTING GUIDE
OVEN PROBLEM	POSSIBLE CAUSES AND/OR REMEDY
Oven does not function	Range is not connected to electrical power. Ask a professional to
	check power circuit breaker, wiring and fuses.
Self-clean cycle does not activate	Door is not shut tight and door latch cannot lock
Door does not open	Oven is still in self-clean mode. Door latch will release when safe
	temperature is reached.
Oven light does not work	Light bulb is burned out.
	Oven is not connected to power.
	Clean cycle is on.
Oven door is locked and will not	Turn the oven off at the circuit breaker and wait 5 minutes. Turn
release after cooling	breaker back on. The oven should reset itself and will be operable.
	Check the circuit breaker or fuse box to your house.
Oven is not heating	Make sure there is proper electrical power to the oven.
	Make sure the oven temperature has been selected.
Oven light is not working properly	Replace or reinsert the light bulb if loose or defective.
Oven light stays on	Check for obstruction in oven door. Check to see if hinge is bent.
	There may be debris/spillage around the lens cover. Wipe lens cover
Cannot remove light cover	area with a clean dry towel prior to attempting to remove the lens
	cover.
Broil does not work	Temperature control knob is rotated too far past broil position
	(500°F); PRE-HEATING indicator will light intermittently
PRE-HEATING indicator lights up	This is a FAULT alarm indicating the failure of the cooling fan/s. Try
intermittently and sound alarm on	resetting by turning both selectors to the OFF position. If the error is
	not repaired, call a qualified technician for diagnosis and repair. If not
	repaired, this error indicator will appear again within 10 seconds once
	the oven is activated in any functions for which cooling fans are
	required to operate, preventing the use of the oven. Set both
	selectors to OFF position and call a qualified technician for repair.
HEATING indicator light turned	This is a FAULT indicating failure of the oven sensor temperature
on intermittently and with sound	probe; in this case cooling fans will start automatically. To reset,
alarm on	switch both selector to the OFF position. To stop buzzer and light
	indicator, disconnect the appliance from the main electrical supply
	and call a qualified technician for repair.
CLEAN indicator light on	Electrical power failure happening during cleaning cycle operation;
intermittently and sound alarm on	cleaning cycle interrupted; cooling fans remains both activated; the
	error will be reset by putting two selectors in OFF position; repeat
	cleaning cycle if needed after 3-4 hours.
CLEAN indicator light turned on	Interruption/Stop of an incomplete cleaning cycle due to a intentional
intermittently, sound alarm off	or accidental displacement of one of the two oven selectors from
	CLEAN position during cleaning cycle operation; put both selectors in
	OFF position, wait that door latch unlocks the door when oven
	temperature is dropped below 500°F(260°C) and then re-select a
	desired oven function.
PRE-HEATING indicator light on	Wrong temperature knob selection in oven functions BROILER or
intermittently, sound alarm on	CONVECTION BROILER (temperature knob positioned not at 500°F
	position, over Tmax or under 450°F position); select OFF position
	and then 500°F on temperature selector;
	Or
	Wrong temperature knob selection for oven functions BAKE,
	CONVECTION BAKE; TURBO, CONVECTION (temperature knob
	positioned over Tmax=500°F position); select OFF position and then
	the desired temperature under Tmax position on temperature
	selector.
	26