ADJUSTING THE LEVELING LEGS
Before you slide the unit under the cabinet, you should adjust the levelling legs to within 1/8” of the opening height. The four leveling legs should be adjusted by unscrewing the leg out to the length required. When the feet are properly adjusted, tighten the locking nuts to the base pan.
(The machine may have an inclination of 2° maximum without affecting its performance.)
ENGLISH
WARNING! Never lay the dishwasher on its front or side. When necessary, lay the unit on its back.
Levelling leg
It is advisable to lay the unit on a tarp or blanket so as not to scratch or damage the floor or the dishwasher.
Locking nut
MOVING THE MACHINE INTO PLACE
WARNING! Make sure you put the slides cups under the legs to prevent damaging the floor or unit when you slide it into place (see page 5).
1.Remove the zip tie holding the hoses and power supply cord in place on the back of the unit, as illustrated at right.
2.Position the machine in front of the cabinet opening.
3.Pull out the drain hose to ensure there are no sharp bends.
4.Start to feed water, drain lines, and electric cord (if necessary) into the access hole in the cabinet.
5.Grip the unit at the top or side edges and gently slide the unit into the dishwasher opening using the slide cups provided with the unit.
WARNING! Never use your knee or shoulder to push the unit in place. You could damage the dishwasher.
6. Check the level and make adjustments if necessary. (See above.)
WARNING! Be careful of sharp edges.
OPENING THE EDW194E CUSTOM DOOR
To open the door panel on the EDW194E, insert your fingers into the rectangular slots on each side of the door and pull.
7