Eurotech Appliances EDW194E, EDW154E, EDW174E owner manual Installing a Custom Wood Panel

WOOD PANELS THE SAME HEIGHT AS THE DISHWASHER DOOR (23-1/4”)

If the custom panel is the same height as the dishwasher door, a 2” decorative fill strip or pull-out cutting board must be used to fill the area between the panel and the counter top (as illustrated at right).

Custom-built 2-inch decorative fill strip or cutting board (not available to order)

28-1/4" 718 mm

23-3/8"

595 mm

ENGLISH

toe kick

INSTALLING A CUSTOM WOOD PANEL

To install the custom wood panel, follow the steps below.

1.Attach the handle (A) to the wood panel. (It is best to use a handle instead of a knob.)

2.Remove the second and fourth screws (B and C) from the inside top of the dishwasher door and discard.

3.With the door slightly open, position the wood panel with the holes in alignment with the door and secure it in place with 2-12” squeeze clamps on both sides.

4.If you are installing a 30-1/16” high panel, it should extend 1-13/16” above the control panel. It’s a good idea to take this measurement before you proceed.

5.Insert the 1-1/2” screws supplied with the unit through the panel and door.

6.Secure the screws.

7.Close the door and, if necessary, adjust level by adjusting the front levelling legs for proper height clearance.

8.Fasten the dishwasher to the cabinet (see page 9).

15