Parkinson Cowan Renown GR Location of Appliance, Parts Required, Grill Assembly

Page 33

R E N O W N G R

LOCATION OF APPLIANCE

This appliance must not be installed in a bed-sitting room of volume less than 20m³ or in a bathroom or shower room. It is essential that the appliance is positioned as stated below. The appliance must be a minimum of 20mm from the rear wall (note that this dimension is provided by the inlet elbow). Shelves, wall cabinets and cooker hoods must not be fitted closer than 500mm to the top of the grill canopy or within 100mm of the sides of the grill. Curtains must not be fitted immediately behind the appliance or within 200mm of the sides of the grill. If fitted next to or between two base units a minimum space of 1mm must be left between the units and the sides of the appliance. The hotplate must be set to a minimum of 7mm above the adjacent units (note that the levelling feet fitted to the appliance will achieve a nominal height to hotplate level of 907mm -5+13mm). Base units not meeting the above conditions must be a minimum of 100mm away from the hotplate. L.P.G. cookers MUST NOT be installed below ground level, i.e. in a basement or fitted aboard any boat, yacht or other vessel.

INSTALLATION

1.PARTS REQUIRED

The loose hotplate parts are packed in the polystyrene fitment on the top of the hotplate. The grill pan, grill pan handle, fixing screws and splashplate fixing screws can be found in the furniture pack which is located in the bottom compartment. The grill pan requires assembly before use (see Fig. 1).

NOTE: Taptite screws are used to secure the handle. These are thread forming screws and sufficient pressure must be applied to allow the screws to produce a thread in the plunged holes.

2.GRILL ASSEMBLY

The two splashplate screws marked A (see Fig. 1a) should be screwed into the back of the appliance about halfway in. Engage the keyhole slots in the splashback behind the two screws taking care not to trap the H.T. wire (see Fig. 1b).

Insert the four splashplate screws marked B (see Fig. 1b). Tighten 6 off splashplate screws (see Fig.1b).

Connect the grill supply union at the back of the appliance and pull the grill H.T. lead through the opening in the splashplate. Feed lead through the hole in the top right hand side of the splashplate and connect on to the grill electrode.

Grill Pan Handle Assembly:

Assemble grill pan (see Fig.1) and secure four screws provided.

Connect grill H.T. lead to grill electrode

Fig.1a

Fig.1b

33

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Owners handbook Installation instructions Introduction For your safetyN t e n t s Grill and hotplate Lighting the cookerOven To lightTo turn off any burner Grill Grill control gives two heat settingsHeat control Cooking positionsPositioning food on the grid PreheatingBurner sizes HotplateFor your Safety Helpful hints Oven Heat zonesOven Shelves Baking trays and dishes For your safety RoastingCondensation Oven cooking chart Mins. per ½ kg 1lb and 15 mins Mins. per ½ kg 1lb and 25 minsMinutes for each ½kg 1lb ¼-2½ hoursBaked custards Mins Yeast Mixtures TrayMins Cooking Mins Rolls and bunsSlow cooking Food preparation slow cookingJoints of meat and poultry Vegetables Soups, casseroles and stewsMilk puddings General points for slow cooking Frozen foodsReheating Care and cleaning For your safety Cleaning the brass plated handleHotplate Grill When replacing hotplate burner partsGeneral Follow the oven cleaning cycle regularlyBoil over Oven roofOven cleaning cycle Installing the cooker For your safety LocationFor further details see Positioning Cooker dimensionsOverall height 1457mm 1475mm Height to hotplate 902mm 920mm Width 498mm DepthGeneral information For your safety BatteryMoving your cooker Reversing the oven door StorageProblem What is wrong and why?Check LCheckHaving difficulty cleaning any part of the cooker Gas Consumers Council Servicing For your safetyInstallation Instructions Connections DimensionsIgnition GrillProvision for Ventilation Important Safety RequirementsGrill Assembly Location of ApplianceParts Required Fitting the Stability Bracket Levelling the ApplianceConnecting to GAS Fitting the BatteryPressure Testing Checking the Hotplate Checking the GrillChecking the Main Oven General NoteN O Wtensg R Renown GR Contents Check List Description
Top Page Image Contents