Cover Knob Assembly:
1.Position disc and cover knob on topside of cover aligning hole in disc and cover knob with hole in cover.
2.Insert screw with washer and plastic sleeve attached, through cover hole into knob. Tighten with screwdriver until
secured. Do not over tighten to prevent stripping of threads. Do not use cover without cover knob attached.
Grill Assembly:
•Always use grill on a dry, level,
1.Place drip pan into base. Fill drip pan with water to maximum water level line, about 3 cups.
2.Position grill onto base with handles in recessed areas of base. Grill may be positioned with control to left or right end of base.
3.With the heat control set at the OFF position, plug cord into a 120 volt AC electric outlet only.
4.Preheat grill, uncovered, at recommended setting for food being cooked. Refer to grilling chart in this manual or on handle for selecting the heat setting and grilling times.
5.When signal light on heat control goes out indicating grilling temperature has been reached, add the food. If desired, cover may be placed on grill to shorten cooking time and help contain spatters. Heat may be increased or decreased, depending upon personal preference and type or amount of food being prepared. The signal light will go on and off periodically to indicate that proper temperature is being maintained.
6.Use hot pads when handling grill and cover as handles become warm. For turning food, nylon, plastic or wooden cooking tools are recommended for use on the
7.When grilling is completed, set heat control at WARM for serving, or set dial at OFF if food will be removed immediately from grill. After dial is set at OFF, unplug cord from wall outlet. Let grill cool completely before removing heat control.
8.Unplug cord from electric outlet after use and allow the electric grill to cool completely before cleaning.
9.Do not allow children to use the grill or be around the electric grill, as the outside surfaces of the grill are hot during use.
5