Multiquip QP-40TE manual QP- 40TE Initial START-UP Engine

QP- 40TE — INITIAL START-UP (ENGINE)

6.Grasp the starter grip (Figure 12) and slowly pull it out.The resistance becomes the hardest at a certain position, corre- spondingtothecompressionpoint.Pullthestartergripbriskly and smoothly for starting.

Figure 12. Starter Grip

7.If the engine has started, slowly return the choke lever (Figure 13) to the CLOSED position. If the engine has not started repeat steps 1 through 6.

CAUTION

ALWAYS run engine at full speed while pumping.

Stopping The Engine

Normal Shutdown

1.Move the throttle lever to the IDLE position (Figure 15) and run the engine for three minutes at low speed.

Figure 13. Choke Lever (Closed)

8.Before the pump is placed into operation, run the engine for severalminutes. Checkfor fuelleaks,andnoisesthatwould associate with a lose component.

9.To begin pumping, place the throttle lever (Figure 14) in the "RUN"position.

Figure 14. Throttle Lever (Run)

Figure 15.Throttle Lever (Idle)

2.Aftertheenginecools,turntheengineON/OFFswitchtothe “OFF” position (Figure 16).

Figure 16. Engine ON/OFF Switch (OFF)

3.Place the fuel shut-off lever (Figure 17) in the OFF position.

Figure 17. Fuel Valve Lever (OFF)

Emergency Showdown

1.MovethethrottleleverquicklytotheIDLE position,andplace the engine ON/OFF switch in the OFF position.

QP- 40TE — OPERATION & PARTS MANUAL — REV. #0 (04/13/05) — PAGE 19