Multiquip QP-40TE manual QP- 40TE Safety Message Alert Symbols, Manufacturers, Safe operation

Page 6

QP- 40TE — SAFETY MESSAGE ALERT SYMBOLS

FORYOUR SAFETY AND THE SAFETY OF OTHERS!

HAZARD SYMBOLS

Safety precautions should be followed at all times when operating this equipment. Failure to read and understand the Safety Messages and Operating Instructions could result in injury to yourself and others.

 

This Owner's Manual has been

 

developed to provide complete

 

instructions for the safe and efficient

 

operation of the MultiquipModel

NOTE

QP- 40TE Trash Pump. Refer to

 

the

engine

manufacturer's

 

instructions for data relative to its

 

safe operation.

 

Before using this pump, ensure

 

that the operating individual has

 

read

and

understands all

 

instructions in this manual.

SAFETY MESSAGE ALERT SYMBOLS

The three (3) Safety Messages shown below will inform you about potential hazards that could injure you or others. The Safety Messages specifically address the level of exposure to the operator, and are preceded by one of three words: DANGER, WARNING, or CAUTION.

DANGER

You WILL be KILLED or SERIOUSLY INJURED

if you DO NOT follow these directions.

WARNING

You CAN be KILLED or SERIOUSLY INJURED if

you DO NOT follow these directions.

CAUTION

You CAN be INJURED if you DO NOT follow these directions.

Potential hazards associated with the QP-40TE Trash Pump operation will be referenced with Hazard Symbols which appear throughout this manual, and will be referenced in conjunction with Safety Message Alert Symbols.

WARNING Lethal Exhaust Gas Hazards

Engine exhaust gases contain poisonous carbon monoxide. This gas is colorless and odorless, and can cause death if inhaled. NEVER operate this equipment in a confined area or enclosed structure that does not provide ample free flow air.

WARNING Explosive Fuel Hazards

Gasoline is extremely flammable, and its vapors can cause an explosion if ignited. DO NOT start the engine near spilled fuel or combustible fluids.

DO NOT fill the fuel tank while the engine is running or hot. DO NOT overfill tank, since spilled fuel could ignite if it comes into contact with hot engine parts or sparks from the ignition system. Store fuel in approved containers, in well-ventilated areas and away from sparks and flames.

 

WARNING

Burn Hazards

Engine components can generate extreme heat. To prevent burns, DO NOT touch these areas while the engine is running or immediately after operations. Never operate the engine with heat shields or heat guards removed.

WARNING Respiratory Hazards

ALWAYS wear approved respiratory protection when required.

PAGE 6 — QP- 40TE —OPERATION & PARTS MANUAL — REV. #0 (04/13/05)

Image 6
Contents Model QP-40TE Page QP- 40TE Operation & Parts Manual REV. #0 04/13/05 Table of Contents Parts Ordering Procedures Wilmington Ave Carson, CAManufacturers QP- 40TE Safety Message Alert SymbolsAlways wear approved respiratory protection when required Safe operationQP- 40TE Safety Message Alert Symbols Free flow of cooling air QP- 40TE Rules for Safe OperationAlcohol Serious damage toQP- 40TE Rules for Safe Operation QP- 40TE SPECIFICATIONS/DIMENSIONS Pump Suction & Discharge SizeSpecifications Engine QP- 40TE General Information ApplicationRe-prime later Attempting to remove clean-out coverWater PortQP- 40TE Refueling Plastic TRUCK-BED LinerQP- 40TE Basic Engine QP- 40TE PRE-INSPECTION Engine Engine is hot! or runningQP- 40TE PRE-SETUP Pump Read safety instructions at the beginning of manualPlace the engine ON/OFF switch in the on position QP- 40TE Initial START-UP EnginePlace the engine fuel valve lever to the on position QP- 40TE Initial START-UP Engine Place the fuel shut-off lever in the OFF positionQP- 40TE Maintenance Pump Pump Vacuum TestQP- 40TE Maintenance Pump QP- 40TE Maintenance Engine Engine Maintenance ScheduleQP- 40TE Maintenance Engine QP- 40TE Preparation for Long -TERM Storage Pump StorageQP- 40TE Operation & Parts Manual REV. #0 04/13/05 QP- 40TE Troubleshooting Engine Engine TroubleshootingQP- 40TE Troubleshooting ENGINE/PUMP Sample Parts List Indicated byQP- 40TE Suggested Spare Parts QP- 40TE Pump Assy Pump AssyCasing Cover ENGINE, RobinCasing Delivery Cover NPT432 QP- 40TE -OPERATION & Parts Manual REV. #0 04/13/05 Spring Washer M12 NUT DELIVERY/SUCTION Cover M12Pump M10 Spring Washer M10Robin EX270D50021 Engine Crankcase Assy Crankcase AssyOIL SEAL, 28.8DX45DX7T Valve GUIDE,5.5DX9.5DX27LStem SEAL, 5DX11.6DX15DX7.8T Ball BEARING, BB6206, 30DX62DX16BRobin EX270D50021 Engine Crankshaft Assy CRANKSHAFT, Piston AssyWoodruff KEY, 3BX6HX16D Crankshaft CP, 1 PumpFlange NUT, M18X31DX14H Piston PIN, 18DX13DX53LRobin EX270D50021 Engine Intake and Exhaust Assy Intake and Exhaust Group AssyPIN, CAMSHAFT, 9DX78.5L Adjust SCREW, M5X0.5X23LCamshaft CP Spring PIN, 4DX7.5DX11LRobin EX270D50021 Engine AIR Cleaner Assy AIR Cleaner AssyLabel Base CPCover NUTRobin EX270D50021 Engine Governor Assy Governor Group AssyGovernor Shaft SPRING, AdjustGovernor Lever Governor ROD CPRobin EX270D50021 Engine COOLING/ Starting Assy Cooling and Starting Group AssyBaffle 2, Head LABEL, Trade Mark 64DBaffle 1, Case CP BoltRobin EX270D50021 Engine Fueltank Assy FUEL, Lubricant AssyFuel Tank CAP CP LABEL, WarningLABEL, Model UnionRobin EX270D50021 Engine Carburetor Assy Carburetor AssyValve Choke Screw AdjustingValve Throttle JET SlowRobin EX270D50021 Engine Flywheel Assy Flywheel AssyIgnition Coil CP Wire 1 CPSwitch Assy Lamp Coil CP, 15WEX270D50021 Engine Electric Device Assy Electric Device AssyOIL Sensor CP Tapping BoltClamp CP Effective October 1, 2002 Terms and Conditions of Sale Parts QP- 40TE Operation & Parts Manual REV. #0 04/13/05 Heres HOW to GET Help Your Local Dealer is