Motion Computing C5 manual Charging the battery, Removing and replacing the battery

Page 35

Charging the battery

When the C5 is connected to AC power, the battery automatically charges until it reaches full charge, whether the unit is on or off.

For information about the battery status light, see “Status lights” on page 8.

DANGER: To avoid injury, keep the battery within the recommended temperature range when charging it. If the battery has been subjected to extreme temperatures, wait until it cools to room temperature before recharging it. For more information, see the Safety and Regulatory Guide packaged with the C5.

Removing and replacing the battery

Before you remove the battery, ensure that the C5 is plugged in, turned off, or in Hibernate or Standby mode (page 31).

To remove the battery

1.With the back of the unit facing you, slide and hold the battery latch.

2.Insert your finger under the finger grip and remove the battery from the battery compartment.

Chapter 3 Using the Motion C5

Image 35

Contents User’s Guide AuthenTec is a registered trademark of AuthenTec, Inc Getting Started Front OverviewTop side Right sideBack side Under Pen, tap Calibrate Digitizer Setting up the Motion C5Tablet PC Tutorials To calibrate the digitizerGet familiar with the Motion C5 Features2 Status lights PenWindows Security button Front panel buttonsSecurity DisplayFingerprint reader Microphones CameraDataGuard Rfid reader Docking connectorSpeaker UPC-A UPC-E Bar code scanner optionalBattery Wi-Fi 802.11a/b/g wirelessBluetooth wireless Power adapter Features Using the Motion C5 To start Motion Dashboard Using Motion DashboardTap the Pen & Button Options button Using the penConfiguring pen options To configure pen optionsTo use the camera Using Tablet PC Input PanelUsing the camera To start Input PanelTap Change Configuring front panel buttonsTo configure the front panel buttons Tap Pen and Button Options Tap the Tablet Buttons tabChanging the screen orientation Using the displayAdjusting the display brightness To change the rotation sequence Changing the display rotation sequenceTo use the bar code scanner Using the bar code scannerTo use the Rfid reader Using the Rfid readerTo set up the angle of acceptance Using the built-in microphonesSetting up the angle of acceptance To set up the skew angle Using speech recognitionSetting up the skew angle Starting speech recognition Setting up speech recognitionTo set up speech recognition Select Dictation or CommandsUsing power management To put the computer on Standby Using StandbySelect Enable Hibernation To put the computer on Hibernate Using HibernateTo enable Hibernation To check the battery gauge Using the batteryChecking battery power To check the remaining battery powerTo remove the battery Charging the batteryRemoving and replacing the battery To swap batteries Swapping the batteryTo replace the battery Disposing of used batteries Battery and power management tipsTo capture a fingerprint Using Motion OmniPass and the fingerprint readerCapturing a fingerprint To start Motion OmniPassPage Fingerprint reader tips To run the password wizard Using password replacementUsing the password wizard To register passwordsLogging on to a remembered site Setting up strong logon securityTo enable strong logon security To configure authentication rulesUsing Windows Security Center Setting a Bios password Setting up users and passwordsSetting up Windows user accounts Enabling or disabling Wi-Fi Using Wi-Fi 802.11a/b/gSetting up a hard disk drive HDD password Enabling or disabling Bluetooth Using BluetoothSetting up a Wi-Fi connection To set up a Bluetooth connection Setting up a Bluetooth deviceIf the device is not discovered… Bluetooth wireless tipsFinding additional software General care Care and MaintenanceStandard display View Anywhere displayDisinfecting procedures Cleaning in a health care environmentTraining and documentation considerations Cleaning the fan coverCleaning solutions To clean the fan coverTo clean the fingerprint reader Cleaning the fingerprint readerTo replace the pen tip Traveling with the Motion C5Replacing pen tips Ordering new pensTraveling by air FAA Wireless air travel requirementUsing Acronis True Image in Windows Restoring dataUsing Acronis Startup Recovery Manager Creating a backup archiveCreating a bootable disk Tap Remove Acronis OEM Zone Removing the Acronis OEM ZoneTo remove the OEM Zone Care and Maintenance Computer does not shut down TroubleshootingComputer will not enter Hibernation mode Computer does not turn onDesktop area is larger than the C5 display Battery does not last very long less than three hoursDisplay goes black while the C5 is still turned on Lost data while swapping batteriesFunction button does not work C5 does not respond to the pen I am usingExpand Display adapters Pointer on the screen does not align with the penComputer seems to be operating more slowly than usual No sound is coming from the speakersFrequently asked questions How do I adjust the C5 for left-handed use? SpecificationsWarranty and insurance programs Service and support Appendix a Troubleshooting and Support

Related manuals

Manual 86 pages 47.69 Kb