Motion Computing C5 manual Using Wi-Fi 802.11a/b/g, Setting up a hard disk drive HDD password

Page 45

Setting up a hard disk drive (HDD) password

You can use a HDD password to protect the computer and the hard disk drive. The computer cannot be started without the HDD password, and the data on the disk drive cannot be accessed, even if it is removed and attached to a different computer.

To set up an HDD password

1.Start the Motion C5 (page 5).

2.When the Motion Computing splash screen appears, tap the screen with the pen. On the TrustedCore menu, tap Launch System Setup. If you miss the splash screen, restart the computer and try again.

3.In the PhoenixBIOS Set Up Utility, tap Security on the menu bar.

4.Double-tapEnter for Set Hard Disk Password.

5.Enter a password using the on-screen keyboard and tap Enter. Enter the password again to confirm it and tap Enter.

6.Tap Exit, then select Exit Saving Changes.

To clear the password, double-tap Enter for Set Hard Disk Password. Enter the current password, then tap Enter twice to leave the Enter New Password fields blank.

Using Wi-Fi (802.11a/b/g)

Use the information in this section to set up a Wi-Fi connection. Wireless access requires an 802.11a, 802.11b, or 802.11g access point. Internet access requires a working Internet connection.

DANGER: FAA regulations require that you disable any wireless connection when traveling by air. Failure to disable the wireless connection on the C5 while traveling by air can cause communications problems with aircraft instruments.

Enabling or disabling Wi-Fi

Before you can establish a Wi-Fi connection, you must enable the Wi-Fi adapter. You can enable the Wi-Fi adapter using Motion Dashboard.

To enable or disable Wi-Fi

1.Open the Motion Dashboard to the Wireless panel (page 18).

2.Select or clear the Enable Internal 802.11 Wireless check box.

Chapter 3 Using the Motion C5

43

Image 45
Contents User’s Guide AuthenTec is a registered trademark of AuthenTec, Inc Getting Started Front OverviewTop side Right sideBack side Tablet PC Tutorials Setting up the Motion C5To calibrate the digitizer Under Pen, tap Calibrate DigitizerGet familiar with the Motion C5 Features2 Status lights PenWindows Security button Front panel buttonsDisplay Fingerprint readerSecurity Camera DataGuardMicrophones Docking connector SpeakerRfid reader UPC-A UPC-E Bar code scanner optionalWi-Fi 802.11a/b/g wireless Bluetooth wirelessBattery Power adapter Features Using the Motion C5 To start Motion Dashboard Using Motion DashboardConfiguring pen options Using the penTo configure pen options Tap the Pen & Button Options buttonUsing the camera Using Tablet PC Input PanelTo start Input Panel To use the cameraTo configure the front panel buttons Configuring front panel buttonsTap Pen and Button Options Tap the Tablet Buttons tab Tap ChangeUsing the display Adjusting the display brightnessChanging the screen orientation To change the rotation sequence Changing the display rotation sequenceTo use the bar code scanner Using the bar code scannerTo use the Rfid reader Using the Rfid readerUsing the built-in microphones Setting up the angle of acceptanceTo set up the angle of acceptance Using speech recognition Setting up the skew angleTo set up the skew angle To set up speech recognition Setting up speech recognitionSelect Dictation or Commands Starting speech recognitionUsing power management To put the computer on Standby Using StandbyUsing Hibernate To enable HibernationSelect Enable Hibernation To put the computer on Hibernate Checking battery power Using the batteryTo check the remaining battery power To check the battery gaugeCharging the battery Removing and replacing the batteryTo remove the battery Swapping the battery To replace the batteryTo swap batteries Disposing of used batteries Battery and power management tipsCapturing a fingerprint Using Motion OmniPass and the fingerprint readerTo start Motion OmniPass To capture a fingerprintPage Fingerprint reader tips Using the password wizard Using password replacementTo register passwords To run the password wizard To enable strong logon security Setting up strong logon security To configure authentication rules Logging on to a remembered siteUsing Windows Security Center Setting up users and passwords Setting up Windows user accountsSetting a Bios password Using Wi-Fi 802.11a/b/g Setting up a hard disk drive HDD passwordEnabling or disabling Wi-Fi Using Bluetooth Setting up a Wi-Fi connectionEnabling or disabling Bluetooth To set up a Bluetooth connection Setting up a Bluetooth deviceBluetooth wireless tips Finding additional softwareIf the device is not discovered… General care Care and MaintenanceStandard display View Anywhere displayDisinfecting procedures Cleaning in a health care environmentCleaning solutions Cleaning the fan coverTo clean the fan cover Training and documentation considerationsTo clean the fingerprint reader Cleaning the fingerprint readerReplacing pen tips Traveling with the Motion C5Ordering new pens To replace the pen tipUsing Acronis True Image in Windows FAA Wireless air travel requirementRestoring data Traveling by airCreating a backup archive Creating a bootable diskUsing Acronis Startup Recovery Manager Removing the Acronis OEM Zone To remove the OEM ZoneTap Remove Acronis OEM Zone Care and Maintenance Computer will not enter Hibernation mode TroubleshootingComputer does not turn on Computer does not shut downDisplay goes black while the C5 is still turned on Battery does not last very long less than three hoursLost data while swapping batteries Desktop area is larger than the C5 displayExpand Display adapters C5 does not respond to the pen I am usingPointer on the screen does not align with the pen Function button does not workComputer seems to be operating more slowly than usual No sound is coming from the speakersFrequently asked questions Specifications Warranty and insurance programsHow do I adjust the C5 for left-handed use? Service and support Appendix a Troubleshooting and Support
Related manuals
Manual 86 pages 47.69 Kb