Motion Computing C5 manual Cleaning the fan cover, Training and documentation considerations

Page 52

Training and documentation considerations

All users of portable computers in the health care environment should be provided with training on proper cleaning procedures. Cleaning procedures should be added to the institution's policies and procedures for infection prevention.

Cleaning solutions

This section describes various cleaning solutions that have been tested by

Motion Computing. Review the manufacturer's guidelines for proper use of the product.

Product Type	Manufacturer	Comments

Vira-Guard	Veridien	Concentrated Isopropanol. Does not leave film.

Cavi-Wipes	Metrex	Isopropanol and Ethylene Glycol Monobutyl
		Ether. Leaves a slight film which needs a
		secondary wipe with dry cloth to remove.

Sani-Cloth	PDI	Quaternary Ammonium. Leaves a slight film
		which needs a secondary wipe with dry cloth
		to remove.

Cleaning the fan cover

If the fan cover becomes soiled, it can be removed and cleaned.

To clean the fan cover

1.Shut down the C5, unplug it, and remove the battery.

2.Turn the unit over so that the back side is facing up.

3.Press the fan cover release button.

Press

4.Slide the fan cover away from the unit to remove it.

5.Clean the fan cover according to the guidelines for your organization.

6.After the fan cover is clean and dry, slide it back onto the C5 until it snaps into place.

50	Chapter 4 Care and Maintenance

Image 52

Contents User’s Guide AuthenTec is a registered trademark of AuthenTec, Inc Getting Started Overview FrontRight side Top sideBack side Setting up the Motion C5 Tablet PC TutorialsTo calibrate the digitizer Under Pen, tap Calibrate DigitizerGet familiar with the Motion C5 Features2 Pen Status lightsFront panel buttons Windows Security buttonFingerprint reader DisplaySecurity DataGuard CameraMicrophones Speaker Docking connectorRfid reader Bar code scanner optional UPC-A UPC-EBluetooth wireless Wi-Fi 802.11a/b/g wirelessBattery Power adapter Features Using the Motion C5 Using Motion Dashboard To start Motion DashboardUsing the pen Configuring pen optionsTo configure pen options Tap the Pen & Button Options buttonUsing Tablet PC Input Panel Using the cameraTo start Input Panel To use the cameraConfiguring front panel buttons To configure the front panel buttonsTap Pen and Button Options Tap the Tablet Buttons tab Tap ChangeAdjusting the display brightness Using the displayChanging the screen orientation Changing the display rotation sequence To change the rotation sequenceUsing the bar code scanner To use the bar code scannerUsing the Rfid reader To use the Rfid readerSetting up the angle of acceptance Using the built-in microphonesTo set up the angle of acceptance Setting up the skew angle Using speech recognitionTo set up the skew angle Setting up speech recognition To set up speech recognitionSelect Dictation or Commands Starting speech recognitionUsing power management Using Standby To put the computer on StandbyTo enable Hibernation Using HibernateSelect Enable Hibernation To put the computer on Hibernate Using the battery Checking battery powerTo check the remaining battery power To check the battery gaugeRemoving and replacing the battery Charging the batteryTo remove the battery To replace the battery Swapping the batteryTo swap batteries Battery and power management tips Disposing of used batteriesUsing Motion OmniPass and the fingerprint reader Capturing a fingerprintTo start Motion OmniPass To capture a fingerprintPage Fingerprint reader tips Using password replacement Using the password wizardTo register passwords To run the password wizardSetting up strong logon security To enable strong logon securityTo configure authentication rules Logging on to a remembered siteUsing Windows Security Center Setting up Windows user accounts Setting up users and passwordsSetting a Bios password Setting up a hard disk drive HDD password Using Wi-Fi 802.11a/b/gEnabling or disabling Wi-Fi Setting up a Wi-Fi connection Using BluetoothEnabling or disabling Bluetooth Setting up a Bluetooth device To set up a Bluetooth connectionFinding additional software Bluetooth wireless tipsIf the device is not discovered… Care and Maintenance General careView Anywhere display Standard displayCleaning in a health care environment Disinfecting proceduresCleaning the fan cover Cleaning solutionsTo clean the fan cover Training and documentation considerationsCleaning the fingerprint reader To clean the fingerprint readerTraveling with the Motion C5 Replacing pen tipsOrdering new pens To replace the pen tipFAA Wireless air travel requirement Using Acronis True Image in WindowsRestoring data Traveling by airCreating a bootable disk Creating a backup archiveUsing Acronis Startup Recovery Manager To remove the OEM Zone Removing the Acronis OEM ZoneTap Remove Acronis OEM Zone Care and Maintenance Troubleshooting Computer will not enter Hibernation modeComputer does not turn on Computer does not shut downBattery does not last very long less than three hours Display goes black while the C5 is still turned onLost data while swapping batteries Desktop area is larger than the C5 displayC5 does not respond to the pen I am using Expand Display adaptersPointer on the screen does not align with the pen Function button does not workNo sound is coming from the speakers Computer seems to be operating more slowly than usualFrequently asked questions Warranty and insurance programs SpecificationsHow do I adjust the C5 for left-handed use? Service and support Appendix a Troubleshooting and Support

Related manuals

Manual 86 pages 47.69 Kb